D&D Technologies LokkLatch Magnetic User manual

12
35
Hi-Performance Hardware
Installation Instructions
#2#2
I
4
8
78
1
2
3
4
Ensure housing is in vertical
position before fitting the Push Rod.
III
1/2” (13mm)
*
3
/
8
”–1
1
/
4
” (10mm–32mm)
#2
II
3/16” (5mm)
*#1
Note
I
II III
IV
1
2
3
4
#1
IV Groove
Surco
Cannelure
III
*
5/32” (4mm)
5/32” (4mm)
1/2” (13mm)
31/2” (90mm)
File
Lima
Lime
6
Use file to ensure push rod is square
and does not extend beyond post more
than 3/16” (5mm).
3/16” (5mm).
FIT THE TRIM COVERS
GAPVARIANCE
GATEFRAME
Trim covers cannot be removed once fitted.
INSERT PUSH ROD FIRMLY INTO HOUSING UNTIL GROOVE IS ALIGNED WITH HOUSING
Not suitable for child safety gates - Use MagnaLatch instead.
DRILL PUSH-ROD THROUGH-HOLE INTO GATE
Front Back
Fitting Jig
Refer to Bon back page
Ensure hole through gate is level
Refer to A on back page
FASTEN LATCH TO GATE SAW PUSH-ROD FLUSH WITH FITTING JIG
Fitting Jig
Do NOT cut push-rod at an angle
Gate Post
ALIGN AND FASTEN THE EAK
INSTALLING EXTERNAL ACCESS KIT (EAK) Firmly tighten screws on all components. INSERT DRESS CAPS
File

Adjust keeper so that the raised bump
aligns with same on latch.
LLMINSTR000PA • instr LL MAGNETIC 3 4 13
MAINTENANCE: REMOVE KEY FROM LOCK AFTER USE. Do not lubricate
with petroleum-based products. Ensure all screws are tightened firmly
and that the latch is kept free of ice, dirt and other debris which could
impair performance. Periodic horizontal and/or vertical adjustment may
be required.
9
12
Hi-Performance Hardware
10
Tube helps protect locks from corrosion.
NOT mandatory.
Hole # 2 on fitting jig is for recessing side
fixing legs on Latch for wood gates
#2
5/8” (16mm)
11 WIND SCREW TO JOIN COMPONENTS
Removing Screw Covers (if necessary)
1. Insert blade horizontally underneath cover
2. Twist screwdriver and remove
3. See Step 8 to replace
Adjust keeper so that the raised bump
aligns with same on latch
A
B
#2
FENCE POST
Poste de cerca
Poteau de clôture
FENCE POST
Poste de cerca
Poteau de clôture
MARK AND INSTALL KEEPER TO POST CHECK VERTICAL ALIGNMENT
GATEFRAME
CHECK HORIZONTAL ALIGNMENT
Available from - GatesPlus - www.gatesplus.com.au