D&F DESIGN Wood Porch Swing User manual

PART LIST
A
B
C
D
E
AA
BB
Swing Back
Swing Seat
Left Armrest
Right Armrest
Support Pannel
Chains
M8x55mm Bolt
M4x45mm Screw
1
1
1
1
2
8
8
4
Insert support pannel into(E) the groove on the left armrest(C). Attach the left
armrest(C) to support pannel (E) by using screws (EE) through each hole of the
left armrest into support panel (E).
Repeat the instructions for the right armrest (D).
Note: Screwdriver not provided
Place the chair seat (B) on a flat, soft surface.Attach support pannels (E) to the
chair seat (B) by using M8 bolts (AA), washer (BB) and nut (CC) through each
hole of the support pannels (E) into the chair seat (B).
- 1 -
IMPORTANT!! PLEASE READ ENTIRE
INSTRUCTION SHEET BEFORE ASSEMBLY!!
Wood Porch Swing
Identify all parts packed in the carton against the parts list. Remove all protective
materials. Place parts on a non-abrasive surface. If you are missing any parts or
Are unsure how to proceed with assembly, please call customer service center
Immediately at 844-836-4055 (Monday-Friday, 9: 00 am-5:00pm CST) or e-mail:
[email protected]
Do not attempt to assemble the product if any parts are missing or damaged .
Step 2
Step 1
Note: Do not fully tighten the bolts.
CC
Hex Wrench 1
F 2
Washer 16
Nut
DD
EE
E
C
DD
E
B
AA
BBBBCC

Attach the armrests (C&D) to the swing back (A) by using the long bolts, washers and nuts on
the chains(F) through each hole of the armrest (C&D) into swing back (A).
Step 3
Note: Do not fully tighten the bolts.
Make the short bolt on the chain(F) through the hole of the armrest. Attach the chains (F)
to the swing seat by using the short bolts, washers and nuts on the chains(F) through the
hole of the swing seat (B).
Step 4
Note: Do not fully tighten the bolts.
Step 5
Attach swing back (A) to swing seat (B) by using the M8 bolts (AA), washers (BB) and
nuts (CC) through each hole of the swing back into swing seat.
Fully tighten all the bolts and nuts by wrench (EE).
Now the swing is ready for your enjoyment!
- 2 -
F
A
AABBBBCC
F
B
A
B