Daniamant DAN M4-A User manual

1
M4 W4 IMI ver 2, (D0615)
The DAN M4-A is a ashing lifejacket light which is acvated manually. The DAN W4-
A can be acvated manually or by water sensor.
Daniamant A/S
Industrivej 24 C, DK-3550 Slangerup - DENMARK
Telephone : [phone] Facsimile: [phone]
www.daniamant.com
Descripon
DAN M4-A / W4-A Lifejacket Light
Installaon and Maintenance Instrucons

2
M4 W4 IMI ver 2, (D0615)
The DAN M4-A / W4-A lifejacket light is for use on all types of lifejackets.
The DAN M4-A / W4-A light can be supplied with xing clips or a recessed housing. The clips is intend-
ed to be placed behind a strip of lifejacket material or reecve tape or clipped on to the tube of an in-
atable lifejacket: the light is secured by pressing it into the clip.
The recessed housing is designed to be ed into a cut out on a foam lifejacket.
An illustraon showing a typical aachment methods is shown
It is the responsibility of the lifejacket manufacturer to ensure that the light is aached securely and is
in the correct posion on the lifejacket to provide maximum visibility when the wearer is in the water.
Installaon
The DAN W4-A is switched on automacally when the sensor is immersed in water; no user acon is
required. The light can be switched on and o by operang the clearly marked switch on the top of the
surface for at least 1 second. The DAN M4-A is operated by the manual switch only.
*Manual operaon requires the user to press and hold the switch for at least 1 second : when turning
the light on it will emit 2 ashes in quick succession indicang it is going in to ash mode and that the
switch now can be released. Turning the light o; press and hold the switch for 1 second the light will
emit a steady light when pressed. Now release the switch and the light will turn o.
Operaon
Strap mounted example Recessed mounted example
DAN M4-A / W4-A units are maintenance free, but the following cheks should be made annually:
1. Inspect the light and its aachment for signs of damage or corrosion.
2. For DAN W4-A, a test probe (Daniamant Part No. 1990) can be used to test the water sensor switch.
Alternavely a paper clip may be applied to the two water contacts.
3. For DAN M4-A DAN W4-A, test the light by operang the switch as described above * The light must
ash. Operate the switch again, and the light must stop ashing.
It is recommended that the light is acvated for one minute.
Maintenance, Roune service

3
M4 W4 IMI ver 2, (D0615)
Store between –30 C and +65 C
Safety
Daniamant marine safety light systems have a design life of 5 years. The baeries are herme-
cally sealed pressurised primary Alkaline/Manganese cells, and as supplied are environmental-
ly protected by a moulded plasc housing. In this condion the units poses no denable haz-
ard to health.
Informaon on the composion and behaviour of these products is contained in the Product
Safety Data Sheet , available from our website www.daniamant.com or on request.
Health and Safety informaon
The storage life of the DAN M4-A / DAN W4-A baeries is ve years from the date of manufac-
ture; the expiry date is clearly marked on the unit. On expiry the light should be carefully re-
moved, and a new DAN M4-A / W4-A ed.
Life

4
M4 W4 IMI ver 2, (D0615)
Daniamant´s Survivor Locaon Lights contain baeries as well as electrical and electronic
components, and must therefore be segregated from the domesc waste stream and recy-
cled. Disposing of this product correctly will help save valuable resources and prevent any
potenal negave eects on human health and the environment, which could otherwise
arise from inappropriate waste handling. Daniamant´s lights are marked with the symbol
below which conveys that this waste must be treated separately from household waste.
To ensure compliance with the WEEE and Baery Regulaons, the Survivor Locaon Lights
placed on the market in the UK or Denmark should be returned to Daniamant in the UK or
Denmark, or disposed in your nearest WEEE Designated Collecon Facility, operated by your
Local Authority.
Product Disposal Instrucons
Further copies of this installaon and maintenance instrucons are available to download
from our website www.daniamant.com
A copy of these instrucons must be held with the ships/owners training manual.