DARCHE RANGER SOLO + User manual

DARCHE.COM.AU
INSTRUCTION MANUAL
050801183R
RANGER SOLO +

2
INSTRUCTION MANUAL
CONTENTS
• 1 x Ranger Solo + swag
• 2 x Aluminium swag poles
• 1 x 50mm high-density foam mattress
• 1 x Dry roll bag
• 6 x Pegs
• 1 x Guy ropes
• 1 x Aluminium pole repair sleeve
WATCH THE VIDEO

DARCHE.COM.AU
Step 1
Unroll the swag onto a flat, well-drained area free of sharp objects that may penetrate the swags PVC floor.
Assemble the two aluminium poles. The poles are dierent in length, and correspond to specific placement on
the swag.
Step 2
Feed the pole through the sleeve on the top of the swag and insert it into one of the pins, while you support the
weight of the swag with your other hand.
PLEASE NOTE
Prior to first use of the Ranger Solo + swag, it is important to remove the mattress from its compression sleeve and
allow it to expand.
Seasoning the swag is not essential but is recommended. For full instructions on seasoning your DARCHE swag, see
How to Season Your Swag (page 7).

4
INSTRUCTION MANUAL
Step 3
DUSK TO DAWN
Before attempting to insert the aluminium pole into the second pin, ensure the pole sleeve is centred on the pole.
Place you palm under the pole end, and push upward until there is a gap between the pole end and the second pin.
Insert the second pin.
IMPORTANT: DO NOT BEND THE POLE TO INSERT THE SECOND PIN.
Repeat this process for the other pole whilst correcting the swag skin as you assemble.
Step 4
12
34
56
Clip the swag to the aluminium poles. A good technique for attaching the clips is to alternate from one side to the
other - top left, then top right, second left and then second right and so on.

DARCHE.COM.AU
Step 5
Using the steel pegs provided, place one through the ring on the front of the swag and secure it to the ground. Then
peg out each of the base corner rings to secure the swag to the ground. Insert a guy rope through the eyelet at the
end of the swag, loop the guy rope around a steel peg and secure it to the ground. Tension the guy rope. Your Ranger
Solo + swag set up is now complete.