BEFORE USING THE PRODUCT,
BE SURE TO READ THE FOLLOWING:
To maintain safety:
The following instructions are intended for the users, operators and the personnel in charge of
the operation of the product. To ensure the safe operation of this product, be sure to follow the
instructions. Read and underatand the warning messages and safety guidelines thoroughly and
handle the product appropriately. Keep this manual close to the product or in a convenient place for
future reference.
Herein, explanations which require special attention are enclosed with dual lines. Depending on
the potentially hazardous degrees, the terms of DANGER, WARNING, CAUTION, etc. are used.
Be sure to understand the contents of these terms before reading the main text.
Indicates that mishandling the
product by disregarding this
pictograph will cause severe
injury or death.
Indicates that mishandling the
product by disregarding this
warning will cause a potentially
hazardous situation which can
result in death or serious injury.
Indicates that mishandling the
product by disregarding this
caution will cause a potentially
hazardous situation which can
result in minor injury and/or
material damage.
For the safe usage of the product, the following pictographs are used:
Indicates "HANDLE WITH CARE." In order to protect the human body and equipment,
this display is attached to places where the instruction manual should be referred to.
•In the case where warning labels are soiled or peel off, replace them immediately.
To ensure safety for the customers, labels and printed instructions describing potentially
hazardous situations are applied to places where accidents can be caused. If any label is peeled
off, apply it again immediately.
• In the case where commercially available monitors and printers are used in this product, only the
contents relating to this product are explained herein. Some commercially available equipment
instruction manual of such equipment.
* Descriptions herein contained may be subject to improvement changes without notice.
* The contents described herein are fully prepared with due care. However, should any question
arise or errors be found, please contact DARTSLIVE Co., Ltd.
INSPECTIONS THE PRODUCT IMMEDIATELY AFTER TRANSPORTING TO THE LOCATION
Normally, DARTSLIVE Co., Ltd. products are despatched in a status allowing for immediate
usage after transporting to the location. Nevertheless, an irregular situation may occur during
transportation. Before turning on the power, check the following points to ensure that the product
has been transported in a satisfactory status.
Are there any dented portions or defects (cuts, etc.) on the packaging and/or cabinet surface?
Are casters and adjusters damaged?
Do power cords have cuts and dents?
Are all accessories available?