Datalogic HF-CNTL-IND-02 User manual

HF-CNTL-IND- 0 2 I N S T A L L A T I O N G U I D E – R E V . 0 5 P A G E 1 O F 2 1
COBALT HF-CNTL-IND-02
RFID CONTROLLER
High Frequency Passive Radio Frequency Identification Controller












IN S T AL L AT I O N GU I D E
How to Install and Setup
Cobalt HF-CNTL-IND-02 RFID Controller
HF-CNTL-IND-02 INSTALLATION GUIDE – REV. 05
Copyright © 2010 Datalogic Automation S.r.l., all rights reserved

HF-CNTL-IND- 0 2 I N S T A L L A T I O N G U I D E – R E V . 0 5 P A G E 2 O F 2 1
REGULATORY COMPLIANCE
FCC COMPLIANCE
Modifications or changes to this equipment without the expressed written approval of
Datalogic could void the autority to use the equipment.
This device complies with PART 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference that may cause
undesired operation.
FCC ID : E36-0001
NOTE:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.

HF-CNTL-IND- 0 2 I N S T A L L A T I O N G U I D E – R E V . 0 5 P A G E 3 O F 2 1
RADIO COMPLIANCE
ENGLISH
Contact the competent authority responsible for the management of radio frequency
devices of your country to verify any possible restrictions or licenses required. Refer to
the web site:
http://ec.europa.eu/enterprise/sectors/rtte/ for further information.
ITALIANO
Prendi contatto con l'autorità competente per la gestione degli apparati a radio
frequenza del tuo paese, per verificare eventuali restrizioni o licenze. Ulteriori
informazioni sono disponibili sul sito:
http://ec.europa.eu/enterprise/sectors/rtte/
FRANÇAIS
Contactez l'autorité compétente en la gestion des appareils à radio fréquence de votre
pays pour vérifier d'éventuelles restrictions ou licences. Pour tout renseignement vous
pouvez vous adresser au site web:
http://ec.europa.eu/enterprise/sectors/rtte/
DEUTSCH
Wenden Sie sich an die für Radiofrequenzgeräte zuständige Behörde Ihres Landes,
um zu prüfen ob es Einschränkungen gibt, oder eine Lizenz erforderlich ist. Weitere
Informationen finden Sie auf der Web Seite:
http://ec.europa.eu/enterprise/sectors/rtte/
ESPAÑOL
Contacta la autoridad competente para la gestión de los dispositivos de radio
frecuencia de tu país, para verificar cualesquiera restricciones o licencias posibles
requerida. Además se puede encontrar mas información en el sitio Web:
http://ec.europa.eu/enterprise/sectors/rtte/
POWER SUPPLY
This product is intended to be installed by Qualified Personnel only.
This device is intended to be supplied by a UL Listed or CSA Certified Power Unit with
«Class 2» or LPS power source

HF-CNTL-IND- 0 2 I N S T A L L A T I O N G U I D E – R E V . 0 5 P A G E 4 O F 2 1
CHAPTER 1:
CONTROLLER INFORMATION
1 . 1 H F - C N T L - I N D - 0 2 OV E R V I E W
Welcome to the Cobalt HF-CNTL-IND-02 RFID Controller – Installation Guide, this
document will assist you in the installation and setup of the Cobalt HF-CNTL-IND-02
RFID Controller.
The Cobalt HF-CNTL-IND-02 is a feature-rich, high frequency, Radio-Frequency
Identification device that provides read/write RFID data transmission and control
solutions to shop floor, item-level tracking and material handling applications.
The controller is designed to be compact, rugged and reliable, in order to meet and
exceed the requirements of the industrial automation industry.
1.1.1 Package Contents
Unpack the Cobalt Controller hardware and accessories. Retain the original shipping
carton and packing material in case any items need to be returned. Inspect each piece
carefully, if an item appears to be damaged, notify your EMS product distributor.
The Cobalt HF-CNTL-IND-02 RFID Controller product package contains the following
components:
PART NUMBER QTY DESCRIPTION
HF-CNTL-IND-02 1 Cobalt HF-Series RFID Controller (-IND)
17-3124 1 HF-CNTL-IND-02 Installation Guide
20-1950 2 Screw (Socket Head Cap, M5 x 20mm, Hex #4,
18-8 SS)
20-3915 2 Washer (Spring Lock, M5, 18-8 SS)
69-1289 1 Wrench Tool (Hex #4, 4mm, L-key)
00-3000 1 Cobalt HF-Series Configuration Tag
CBL-1487 1 Field Mountable Connector (Straight, 5-pos,
Female, M12 - for connecting power)
Table 1-1: HF-CNTL-IND-02 - Package Contents

HF-CNTL-IND- 0 2 I N S T A L L A T I O N G U I D E – R E V . 0 5 P A G E 5 O F 2 1
1.1.2 Power & Communications Interface
Connection Type: Ethernet
Communication Interface: TCP/IP, Ethernet/IP, Modbus TCP
Data Interface Connector: 4-Pin, Female, M12, D-Code (for Ethernet data)
Power Interface Connector: 5-pin, Male, M12 (for power)
Maximum Cable Length: 100m
1.1.3 HF-CNTL-IND-02 Controller Dimensions
Figure 1-1: HF-CNTL-IND-02 Controller Dimensions

HF-CNTL-IND- 0 2 I N S T A L L A T I O N G U I D E – R E V . 0 5 P A G E 6 O F 2 1
1 . 2 CO B A L T H F - S E R I E S R F I D AN T E N N A S
The Cobalt HF product family currently includes four different RFID
antenna models. Because Cobalt HF Antennas are designed with
different dimensions, they each generate unique RF field pattern and
read/write range.
Figure 1-2: Cobalt HF-Series RFID Antennas
CO B A L T HF RF ID AN T E N N A S –MO D E L S A N D SI Z E S
A N T E N N A M O D E L A N T E N N A S I Z E
HF-ANT-1010-01 10cm x 10cm
HF-ANT-2020-01 20cm x 20cm
HF-ANT-3030-01 30cm x 30cm
HF-ANT-0750-01 7cm x 50cm
Table 1-2: Cobalt HF RFID Antennas – Models and Sizes

HF-CNTL-IND- 0 2 I N S T A L L A T I O N G U I D E – R E V . 0 5 P A G E 7 O F 2 1
1.2.1 HF-ANT-1010-01 Antenna Dimensions
Figure 1-3: HF-ANT-1010-01 Antenna Dimensions

HF-CNTL-IND- 0 2 I N S T A L L A T I O N G U I D E – R E V . 0 5 P A G E 8 O F 2 1
1.2.2 HF-ANT-2020-01 Antenna Dimensions
Figure 1-4: HF-ANT-2020-01 Antenna Dimensions

HF-CNTL-IND- 0 2 I N S T A L L A T I O N G U I D E – R E V . 0 5 P A G E 9 O F 2 1
1.2.3 HF-ANT-3030-01 Antenna Dimensions
Figure 1-5: HF-ANT-3030-01 Antenna Dimensions

HF-CNTL-IND- 0 2 I N S T A L L A T I O N G U I D E – R E V . 0 5 P A G E 1 0 O F 2 1
1.2.4 HF-ANT-0750-01 Antenna Dimensions
Figure 1-6: HF-ANT-0750-01 Antenna Dimensions