MOUNTING Matrix 400™
The following parts are required for mounting:
LT-510 Mini Dome Lighting System
BK-4990 Matrix 400™ Generic LT Bracket
1. The BK-4990 bracket comes already partially mounted (D+A) with
2 M4 screws.
2. Mount the bracket Aonto the LT-510 Mini Dome Busing the 4 M4
countersunk screws in the bag marked "Screws for Brackets-LT-
510 assembling".
3. Swing the bracket D90° and mount the reader Conto it through
the mounting holes on the bracket. Use 4 of the M4 screws in the
bag marked "Screws for Bracket-Bracket-Reader assembling".
4. Wire the LT-510 to the CBX according to the Wiring table below.
5. Remove the Lens Cover and loosen the Locking Knobs as
described in the Reference Manual. Swing the bracket D90°
returning to the reading position.
6. Position and mount the Matrix assembly over the code reading
area at the correct Focus Distance (or range) for your model,
(described in the Matrix Reference Manual).
7. Perform the Focusing procedure described in the Reference
Manual.
8. After Focusing, tighten the Focus and Diaphragm Locking Knobs.
Swing the bracket D90° as previously shown to replace the Lens
Cover. Swing the bracket D90° returning to the reading position
and fix the reader assembly (C+D) to the illuminator assembly
(A+B) with the remaining 2 M4 screws from the bag marked
"Screws for Bracket-Bracket-Reader assembling".
POSITIONING Matrix 400™
code surface
Focus distance = α + β
The best results for this illuminator are obtained when αis
approximately 13 mm (0.5"). The positioning slots on the brackets allow
adjustment to obtain the best results between the reader optimal focus
distance and the illuminator optimal working distance. You can
maximize the reading performance through VisiSet™.
TECHNICAL FEATURES
Supply Voltage 24 Vdc
Power Consumption 92 mA; 2.2 W max.
Optimal Working Distance 12.7 mm (0.5")
Effective Working Range 12.7 - 50 mm (0.5" – 2")
Illumination Area 40 mm @ 25 mm
(1.6" @ 1")
Wavelength 660 nm
Typical Irradiance 20 W/m² @ 12.7 mm
Operating Temperature 0 – 60 °C
Dimensions (L x W x H) 71.9 x 71.9 x 44.2 mm
(2.8" x 2.8" x 1.7")
(without bracket)
Weight 438 g. (without bracket)
WIRING
Wire Color CBX/Matrix Signal Meaning
White Vdc 24 Vdc
Black GND Ground
Shield Earth Earth Ground
COMPLIANCE
LED Class
LED RADIATION
DO NOT VIEW DIRECTLY WITH OPTICAL INSTRUMENTS
CLASS 1M LED PRODUCT TO EN 60825-1:(2001)
CE Compliance
Warning: This is a Class A product. In a domestic environment this
product may cause radio interference in which case the user may be
required to take adequate measures.
19/02/08
C
A
B
D
40 mm
