DAVIS Wheel-a-Weigh 1471 User manual

#1471
ASSEMBLY INSTRUCTIONS
This product is not to be used on boats over 200 lbs.
(91 kg). Capacity is reduced to 100 lbs. (45 kg) on
soft sand.
1. Slide strut into bunk and tap into place, making sure
the strut locks into retainer on both sides. Check from
top of bunk.
2. Slide strut onto the axle with the sloped side facing
out. Line up the hole in the strut with the second hole
in from the end of the axle (the second hole has a roll
pin in it). Attach strut to the axle with 1/4" (6.5 mm)
lockpin, which is the smooth pin. Repeat process on
opposite end of axle. The foot rod should be on the
bottom of the axle (see diagram).
CARRYING THE KAYAK
In use, the boat is usually positioned on the bunks just
off the balance point with weight bias toward the bow.
The foot rod is used to hold the dolly upright while the
boat is being loaded.
3. Thread the straps through the built-in strap guides on
the bottom side of the bunks and then install the
buckles.
4. Inflate tires to NO MORE THAN 14 P.S.I. (14 pounds
per square inch). Use no more than 14 pounds tire
pressure regardless of what may appear on the
tire.
CAUTION: Gas station compressors can easily
overinflate and explode tires. Be careful not to
overinflate.
5. Mount the wheels and attach to 1/2" (1.3 cm) axle by
installing 1/4" (6.5 mm) cotter-type pin on outside of
wheel to prevent it from sliding off.
KAYAK DOLLY
CAUTION: This product is not designed to be towed
behind a vehicle. Damage may occur and will void
the warranty.

REPLACEMENT PARTS
Part Qty
No. Description Req’d
R1471A Tire, Innertube and Hub 2
R1464B Strut and Bunk 2
R1471B Pin Set: 2
Lockpin , 1/4" (6.5 mm), and
Cotter Pin, 1/4" (6.5 mm)
Note: The Kayak Dolly wheel does have an innertube,
but its removal is difficult. Order the entire wheel if the
innertube needs to be replaced.
ONE-YEAR WARRANTY
We warrant our products to be free of defects in material
and workmanship for one year from the date of original pur-
chase. Write for full warranty details.
This warranty does not apply to a unit which has been used
on boats weighing more than 200 pounds (91 kg).
3465 Diablo Avenue, Hayward, CA 94545, U.S.A.
Phone [phone] • Fax [phone]
inf[email protected]
For information about our other fine products,
visit www.davisnet.com
1471_Ins.pdf April 2006
#1471
Kayak Dolly
Strut and Bunk
R1464B
Tire, Innertube
and Hub
R1471A
Pin Set:
Lockpin and
Cotter Pin
R1471B
Foot Rod
Axle
Cotter
Pin
Strap with
Buckle
Bunk
Lockpin
Strut