INSTALLATION
Location & Environment
Electrical Connection
*
*
*
*
Do not place the twin tub in steamy rooms or where the twin tub is directly exposed to rain.
Moisture may destroy the electrical insulation and cause an electric shock hazard.
Place twin tub on a sturdy at surface. If the twin tub is placed on an uneven or weak surface, noise or
vibrations may occur. (Allowable inclination is max. 2 degrees).
Avoid direct sunlight or heating device. As plastic and electrical components are affected by direct
heat, never place the washer near heater, boilers etc.
Do not place or store the washer below 0OC (32OF) to avoid any damage from freezing.
*
This unit is designed to operate from an adequate supply mentioned at the rating label sticked to the rear
of it.
Caution: If the power cord is damaged, it should be replaced by a repair shop appointed by the
manufacturer, because special purpose tools are required.
*
*
Sort the clothes into groups-white, colorfast, non-colorfast, delicates, lint free, lint producer, etc., and
wash according to the LAUNDRY GUIDE. (See Laundry Guide).
Clothes with worn or torn patches should rst be mended. Empty out all pockets and close all side
fasteners. (pocket, covers, belts, etc). Treat bad stains prior to washing.
Insert power cord plug into the power point and switch on.
HOW TO WASH
Preparation
LAUNDRY GUIDE
Washing Time & Wash Action Table
Extremely soiled heavy fabric
Linen, cotton, etc.
Ordinary clothes (underwear, etc.)
Slightly soiled synthetic ber
100% wool, mixed wool knitting, thin synthetic
ber with tags indicating hand washing
10-15 minutes
8-10 minutes
7 minutes
2-5 minutes
2-5 minutes
KIND OF CLOTHING WASHING TIME
*If there is any abnormal vibration during spinning, open the spin dryer lid to stop the spin dryer drum
and rearrange the clothes to be in good balance.
* Should spinning fail to stop within 15 seconds after spin dryer lid is open, the brake is out of order.
Immediately stop using the machine and call Dawlance Customer Service.
Caution: Ensure that the spin dryer drum completely stops before reaching into remove the laundry.
Be specially careful of children.
2. Place the safety cover horizontally on the top.
3. Close the inner lid and spin dryer lid. (The machine will not spin if the spin dryer lid is open)
4. Turn the spin timer to the clockwise direction until you reach the desired spin time position.
1. Set the wash timer knob to position “0”.
2. Select the wash action to the desired position.
3. Open the water faucet and feed water to the water level indicated inside the wash tub.
4. Put detergent and laundry into the wash tub.
5. Set wash time by the wash timer.
How to Wash
HOW TO RINSE
1. Set the wash action to the desired position.
2. Turn the water tap on.
3. When the rinsing water becomes clear, turns off the water tap.
4. Don't operate spinner during water intake of rinse operation.
HOW TO SPIN DRY
1. Put the wet clothes into the spin dryer drum, being sure that they are well balanced as shown below.
Step I Remove the overow lter by pulling it
forward.
Step II Wash off the lint stuck on the overow lter
during overowing.
Step III Re-x the overow lter by rst inserting
its bottom section and then pushing the upper
part rmly into the socket.
Lint Filter
Note: If during washing, some residue or deposits have accumulated in the net, then after
nish washing, remove the lter by rst push down and pull it out.
CLEANING AND MAINTENANCE
At the end of every washing:
Switch off the electricity.
Ensure that timer knob reached back to “0” position.
Wipe off spillage (detergent powder, etc.) and generally wipe over the tub and base with a dry duster.
Note: Cleaning after use will extend the life of your washing machine. Before cleaning
disconnect the power cord from the electrical outlet.
03 04
