DC Power Solutions B-COOL RV Series User manual

www.dcpowersales.com
Installation Manual
RV
RV SERIES SERIES

Installation must be performed by
a professional
Switch off / disconnect battery
before installation
Unit is heavy. Do not handle or
install the unit alone.
Wear goggles and gloves for the installation
Do not remove any protection
provided on the unit.
SAFETY INSTRUCTION
CAUTION : HEAVY

Power Harness
(24v)
Air Conditioner
Air Diffuser
each box contains
Power Harness
(12v)
Remote
Controller Install Screws
Sealing Rubber
(Gasket)

Cutting the Hole
"Measure Twice, Cut Once"
STEP 1.
35.56 cm x 35.56 cm
14 in x 14 in
Recommended Hole Cut Size :

Clean Around the Cut
REMOVE DIRT, DUST, DEBRIS
STEP 2.

Apply Gasket
Apply Appropriate Sealant as needed.
STEP 3.

STEP 4.
Place Air Conditioner on cut hole
Have someone help you place the air conditioner
onto the gasket.

Apply the Insulation Sponge
Cut the insulation sponge at the position of the four nuts.
(make four cuts)
STEP 5.

Connecting the Fixing Screws
Record the remaining length of the screw beyond the holder
Cut off the excess length of the screws
STEP 6.

Install the Holder
Securing rooftop air conditioner to the interior of the vehicle.
STEP 7.

Disassemble the Internal Unit
Remove the Panel first and then the air deflector
STEP 8.

Install the air guide foam
Number of the optional pieces used depends on the thickness
of the roof.
STEP 9.
Main Foam
Optional Pieces

Passing the Wire through Internal Unit
Pass the condenser fan and compressor control harness through
the main part of the internal unit.
STEP 10.

Install Air Deflector onto Internal Unit
Fasten the air deflector to the internal unit using the 4
attachable buckles on the unit.
Connect the air deflector by using the 4 self tapping
screws.
STEP 11.

Passing the Wire through air deflector
Pass the condenser fan and compressor control harness through
the air deflector.
STEP 12.

Connecting the Internal Controller
Connect the condenser harness and compressor harness to the
internal controller.
STEP 13.

Installing the Internal Filters
Attach the Air Diffuser/Control Panel.
Install the Internal Filters on both sides.
STEP 14.

Connect the Power Cable to Battery
Red Wire is connected to the positive pole.
Black Wire is connected to the negative pole.
STEP 15.

FLIP OVER FOR
"OPERATING INSTRUCTIONS"
STEP 16.
Switch on the A/C