DECOMATIC Fitin R115 Parts list manual

Assembly of the roller blind Assembly of the roller blind Assembly of the roller blind
c. Clip the base profile into the fastening clips.
(Position the top slot of the base profile on the fastening clip and
clip in the base profile by giving it a slight turn.)
1b. Assembly of the base profile (with fastening clips)
a. Position the base profile on the window and determine the
positions of the fastening clips by marking the bottom slot.
1a. Assembly of the base profile (without fastening clips)
a. Determine the number of the fastening holes.
Note: Hole distance 50 mm from the end of the profile,
space the further holes evenly.
b. Drill the base profile.
Note: The markings on the profile indicate the positions of
the drilled holes.
c. Fasten the base profile with the screws supplied.
b. Fasten the fastening clips with the screws supplied.
Set in position Clip in
Markings on
the profile
Base profile
50 ==50
Base
profile
Bottom slot
Base profile
46
19
19
Fastening clip
Fastening clip
Base profile
Top slot
2. Assembly of the cover profile
a. Position the cover profile on the guiding groove.
b. Push the cover profile onto the base profile (snaps home at the
end).
DECOMATI C
®
Guiding groove
Cover profile
Cover profile
Base profile
44
44
7,5
46
46
28,5 7,5

Disassembly of the roller blind Installation Material
Installation – Operation – Care
Type R115
© 2002 BENTHIN • Copies – also of extracts – are only permissible with written consent • We reserve the right
to make changes • Errors and omissions excepted • 0802 • 03001846
DECOMATIC
®
Dear Customer,
This dimensionally accurate roller blind was produced especially
for your requirements.
High-quality materials and a design that is perfect in function and
elegance guarantee a long service lifetime and thus ensure a great
deal of pleasure in the bought product.
Please read the following instructions carefully before installing the
blind.
The necessary installation material is supplied together with the
blind.
Your
Manufacturer
Enclosed installation material
Type R115
Fastening screws
1. Use a screwdriver to press up the securing element and release
the cover profile from the base profile (both sides).
2. Draw the cover profile off the base profile.
DECOMATIC
®
Detail
(view from below)
Securing
element
Securing
element
3. Unscrew the base profile and/or carefully
bend up the nose of the fastening clip and
remove the base profile.
Cover profile
Cover profile
Base profile
Base profile
Base profile
Nose of the
fastening clip
Base profile for
clip fastening
or
Base profile
for screw
fastening
Cover strip
Tools required
Philips screwdriver
Twist drill Ø4
Drill
Note: Drill and twist drill only required for base profile for
screw fastening.
Operation/Care
The roller blind Type R115 up to an order height of 1.50 m is
steplessly adjusted by means of a side-mounted chain pull.
Over an order height of 1.50 m the position of the hanging is controlled
by means of a chain holder system. (The chain is fixed in the chain
holder.)
Wipe off any slight soiling of the roller blind fabric using a damp
cloth. Then carefully rub the fabric dry. Brush off any dust.
Chain drive Chain holder
system
Chain holder
Care
Fastening clips
(with screws)
or