DeDietrich GT 334 User manual

GT 330
Fuel oil/gas-fired boilers
300007653-001-D
EN
Assembly
Instructions

2GT 330 20/09/11 - 300007653-001-D
1. Package list
1 Package list
Refer to the applicable price list for any optional features used. Package list: Before starting to assemble the boiler, refer to the table
below to check if you have received all the packages required.
1. Boiler body + Accessories
Boilers supplied with an assembled body
For boiler supplied with the boiler body in bulk
2. Burner door
3. Baffle plates
4. Casing
5. Technical documents
Number of sections 456789
Assembled boiler body
(contents depend upon model) 111111
Accessories package FD 15 FD 15 FD 19 FD 19 FD 19 FD 20
Number of sections 456789
Front section Package 8219-0002 111111
Intermediate section Package 8219-0001 234567
Rear section Package 8553-7072 111111
Setofassemblyrods 111111
Accessories for body in bulk 1 Package FD 9 FD 10 FD 11 FD 12 FD 13 FD 14
Base frame 1 Package FD 30 FD 31 FD 32 FD 33 FD 34 FD 35
Number of sections 456789
Burner door 1 Package BP 13 BP 13 BP 13 BP 13 BP 13 BP 13
Number of sections 456789
Baffle plates 1 Package BP 16 BP 17 BP 17 BP 19 BP 20 BP 21
Number of sections 456789
Casing 1 Package MD7 MD8 MD9 MD10 MD11 MD12
Front panel
All countries except:
China 1 Package MD13 MD13 MD13 MD13 MD13 MD13
China 1 Package MD162 MD162 MD162 MD162 MD162 MD162
Number of sections 456789
1 Package (Content depends upon country) 111111

3
20/09/11 -300007653-001-D GT 330
1. Package list
6. Control panel
All models can be equiped with one of the following control panels:
Number of sections 8 9 10 11 12 13 14
Control panel
S3 MD4
B3 MD3
K3 MD2
DIEMATIC-m3 MD1
Lateral control panel
B3 MD140
K3 MD139
DIEMATIC-m3 MD138

4GT 330 20/09/11 - 300007653-001-D
2. Mounting
2 Mounting
Tools required
- 1 Phillips screwdriver
- 1 hammer
-1knife
- 8 - 13 - 17 - 18 - 19 spanners
- 1 putty gun
- 1 JDTE or JDTE Plus or simplified JD assembly tool
- 1 water pump pliers
- 45 mm spanner or parallel groove clamp
- 1 brush
Warning: Assemble the boiler in the order given by the
numbers of each figure, in compliance with all the
instructions.
Symbols used
Caution danger Risk of injury and damage to equipment. Attention must be paid to the warnings on
safety of persons and equipment.
Specific information Information must be kept in mind to maintain comfort.
ZReference Refer to another manual or other pages in this instruction manual.

5
20/09/11 -300007653-001-D GT 330
2. Mounting
1
FD30 - FD31 - FD32 - FD33 - FD34 - FD35
2

6GT 330 20/09/11 - 300007653-001-D
2. Mounting
3
4

7
20/09/11 -300007653-001-D GT 330
2. Mounting
5
(1) Sandpaper
6
(2) Putty for nipple (Supplied)
Clean the nipples and coat them with the product.
8553N051A

8GT 330 20/09/11 - 300007653-001-D
2. Mounting
7
8
(3) Silicon (supplied)
8553N012

9
20/09/11 -300007653-001-D GT 330
2. Mounting
9
(1) Thermocord (Supplied)
10

10 GT 330 20/09/11 - 300007653-001-D
2. Mounting
11
12
Caution: Do not overtighten. Correct tightening is achieved when the cast iron sections come into contact.