
DSE860 – For connection to DSE RS232 enabled controllers.
DSE865 – For connection to DSE RS485 enabled controllers.
‘Plug and Play’ setup
The DSE860/5 must be setup before it will communicate correctly on your network.
Full setup instructions are contained within the operator manual 057-099 DSE860/DSE865 operating
instructions available from www.deepseaplc.com :
Visit www.deepseaplc.com and select DSE DOWNLOADS.
SPECIFICATION
DC SUPPLY
Nominal voltage 8V to 35V continuous DC
Protection against surges to 60V DC
Power consumption @ 12V DC - 110mA +/- 5%, app. (in 100BaseT mode)
ENVIRONMENTAL SPECIFICATIONS
Operating Temperature -30°C to +70°C
Storage Temperature -40°C to +85°C
Vibration 2g, 10-500Hz, amplitude 0.15mm, 6g desirable
Mechanical Shock N/A
Humidity 85%, relative, non-condensing, up to 85°C
DIMENSIONS
Overall size 86mm x 35mm x 57mm (case rear to case front)
(3.4” x 1.4” x 2.3”)
Mounting type M36 DIN-rail
APPLICABLE CODES AND STANDARDS
DSE860/5 meets or exceeds the following standards
EMC (Emissions and Immunity): EN61000-6-2 Generic Immunity
EN61000-6-3 Generic Emissions
Usage within USA and Canada UL 508, CSA 22.2, NFPA 70 / 110
053-062 ISSUE 1
DEEP SEA ELECTRONICS
DSE860 / DSE865
INSTALLATION INSTRUCTIONS