Do not turn the device over in the process
of work. The device is not designed for this
and will emit crackling and atypical sounds.
!
Service
Keep the device clean.
Before and after each use, remove all
possible dirt by wiping the machine
with a special disinfectant.
Remove Friction Stabilizing O-Ring every
4-6 months and apply some amount of oil
on the thread on the device. Use a special oil
for rotary or sewing machines is.
If necessary, replace the O-ring with
a new one (2 spare O-rings are supplied
with the device).
Safety
Use cartridges with a membrane protecting
device from pigment leakage. Always use
disposable sterile needles and rubber
gloves. Always use wraps or any kind
of protector on your device and RCA cable.
The manufacturer does not have
responsibility for contamination, infection
and any kind of material damage
of the customer caused by negligence
or misuse of the machine or its components.
