
The following table lists the different components of the W-7024 controller:
Component Description Page
Access ports 24 x 10/100/1000BASE-T PoE/PoE+ Ethernet ports 10
Uplink ports 2 x 10GBASE-X ports 11
Management port Allows connection to a separate management network 13
Power, Status, and Peered LED Provides basic monitoring of the controller 13
LCD Allows configuration of LCD behavior and other basic operations 14
Enter button Allows execution of actions on the LCD Screen
Menu button Allows selection of the LCD screen menu
USB interface Allows uploading configuration and image from a USB 2.0 storage device. 16
Serial Console port RJ-45 serial console access port for direct local management 16
Micro-USB console port Micro-USB console access port for direct local management 17
AC in AC power connector 17
Grounding points Provided for attaching the grounding 17
Table 4: W-7024 Controller Components
Access Ports
The W-7024 controller is equipped with twenty-four 10/100/1000BASE-T Gigabit Ethernet (RJ-45) ports. These
port are labeled from 0 to 23. Gigabit Ethernet uses all eight wires and each pair is bi-directional, which means, the
same pair is used for both data transmission and data reception. Figure 3 illustrates the Gigabit Ethernet port pin-
out for an RJ-45 connector. The pins paired on a 10/100/1000BASE-T Gigabit Ethernet port are: 1/2, 3/6, 4/5, and
7/8.
All Power over Ethernet (PoE) capable ports support IEEE 802.3af PoE, providing up to 15.4 W of DC power, and
IEEE 802.3at Power over Ethernet Plus (PoE+), supplying up to 30.0 W of DC power to connected devices, but
the power per port is subject to the total PoE power available in the chassis.
Figure 3: 10/100/1000BASE-T Port Pin Out
Access Port LEDs
Each 10/100/1000BASE-T Gigabit Ethernet port is equipped two LEDs that allow basic monitoring of status,
activity, and configuration of the port.
Dell Networking W-7024 Controller | Installation Guide W-7024 Controller | 10