
101-00337-00 7
To apply the configuration, above, to other stack members, use the following commands. The interface
range used and port-pipes (“port-set 0-1”) designated would depend on the S-Series model. The following
sequence presumes that the subject stack member is an S25P model. For an example of configuring an
S50N model, see Basic Layer 2 Setup and Buffer Tuning of the S50N for Storage Environments.
Step Task Command Syntax Command Mode
1Apply the “eql-hig”
buffer profile to another
stack member.
buffer fp-uplink stack-unit 0-7 port-set 0
buffer-policy eql-hig
For the variable 0-7, enter the stack ID of the stack member
to which to apply the “eql-hig” configuration.
For example, for an S25P switch with a stack ID of 1, the
command is:
buffer fp-uplink stack-unit 1 port-set 0
buffer-policy eql-hig
CONFIGURATION
2Select all ports on the
switch.
interface range gi slot/port - port
For the variable slot/port, enter the stack ID of the target
stack member, along with 1 for the beginning port number in
the range and 24 for the highest-numbered 1GbE port.
For example, for an S25P switch with a stack ID of 1, the
command is: interface range gi 1/1 - 24
If the switch has 10 GbE modules inserted, include the 10
GbE port range in the command, for example:
interface range gi 1/1 - 24, te 1/25 - 28
CONFIGURATION
3Apply the “eql-fp” buffer
profile to the ports
selected above.
buffer-policy eql-fp INTERFACE
RANGE
4Change modes from
INTERFACE RANGE to
CONFIGURATION.
exit INTERFACE
RANGE
5Select all 1GbE ports. interface range gi slot/1 - 24
For slot, enter the stack ID of of the target stack member.
For example, for a stack ID of 1, enter:
interface range gi 1/1 - 24
CONFIGURATION
6Enable flow control on
the 1GbE ports.
flow-control rx on tx on INTERFACE
RANGE
7Change modes from
INTERFACE RANGE to
EXEC privilege.
end INTERFACE
RANGE
8Save the configuration to
non-volatile memory.
write memory EXEC privilege
9Restart the system. reload EXEC privilege
10 Verify that the buffer
profile is applied.
show buffer-profile summary fp-uplink EXEC privilege