Dell STREAK TM1745 User manual

Quick Start Guide | Quick Start Guide
Quick Start Guide

2

Quick Start Guide

About Notes
NOTE: A NOTE indicates important information that helps you make better use of
yourproduct.
__________________
Information in this document is subject to change without notice.
© 2011 Dell Inc. All rights reserved.
Dell™, the DELL logo, and Streak™are trademarks of Dell Inc.; Microsoft®and Windows®are either trademarks or registered
trademarks of Microsoft Corporation in the United States and/or other countries.
Other trademarks and trade names may be used in this manual to refer to either the entities claiming the marks and names or
their products. Dell Inc. disclaims any proprietary interest in trademarks and trade names other than its own.
August 2011 P/N 0FNHM Rev. A00

3
About Your Dell Streak 7 Tablet
1Headphone connector
2Speaker
3Volume-up button
4Volume-down button
5Power and Sleep/Wake button
6Battery-status light
7Back button
8Menu button
9Home button
9
7
3
8
2
45
1
6

4
130-pin connector
2Touch screen
3Force power-off button
4SD-card slot
5SIM-card slot
(on 3G model only)
6Slot door
7Speaker
8Microphone
9Camera
56 21 4
9
8
7
3

5
2
11Camera
2Flash

6
Set Up Your Dell Streak 7 Tablet
1. Insert the SD card (Optional)
2. Insert the SIM card on 3G model (Optional)
3. Charge the battery
Charge the battery of your tablet fully before
using it for the first time.
The battery-status light indicates the
following:
•Red — the battery is charging
•Green — the battery is fully charged
1
1Battery status light

7
Turn on Your Tablet
Press and hold the power button to
turnonyour tablet.
Connect a Headphone
Connect the 3.5 mm headphone to the
headphone connector.

8
Lock Screen
Your tablet enters sleep mode automatically after a preset duration of inactivity. To wake up
your tablet from sleep mode, press the power button once. To unlock the screen, touch and
drag to the top of the screen.
To set the duration after which
the tablet enters sleep mode,
touch Home →Menu →
Settings→Display→Screen
timeout and select the desired
option.