MAINTENANCE
Limescale filter maintenance
WhentheFILTERlightcomeson,theltermust
beregeneratedorreplaced.
Toregeneratethelter,proceedasfollows:
• Turntheapplianceoffbypressing the
and buttonsorthe button(depen-
ding on the model), then unplug from the
mains.
• Removethewatertank.
• Removethelimescalelter.
• PlacetheresinlterinthelterholderJ(g.
11).(Youarerecommendedtodothisover
the kitchen sink).
• Attachthetanktotheresinlter.
• Dissolvethecontentsofthesachetofcitric
acid supplied (K)ina1litrejugoftapwa-
ter.
• Pour the resulting solution into the tank
and allow all the contents to pass through
thelter (about 20 minutes),then wait for
a minimum of 40 minutes to regenerate the
limescalelter.
• Torinsethelimescalelter,llthewatertank
with tap water and allow all the contents to
passthroughthelter.
• When the operation is completed, put the
lterandtankbackinplace.
• Plugtheapplianceintothemainsandturn
on.
• PresstheRESETbuttonto conrm the ef-
ciencyofthe lter. The FILTER light goes
off.
• Theapplianceisreadyforuse.
Please note:
Regeneratingtheresinlterguaranteesitslong-
termefciency.However,after5yearsofuse,it
shouldbereplaced.
Sachetsofcitricacidandthelimescalelterare
availablefromauthorisedcustomerservices.
Rinsing the steam generator
If mineral substances leak from the plate, you
shouldcleanthesteamgeneratorbyrinsingas
follows:
• Make sure the appliance is turned off, un-
plugged from the mains and completely
cold.
• RemovethecapFonthesideoftheapplian-
ce(g.12).
• Use a coin or screwdriver to unscrew the
steamgeneratorcap(g.12).
• Resttheapplianceonitsside(g.13)andll
withamaximumof0.7litresofwaterusing
afunneltoavoidthewaterspillingoutside
the steam generator.
• Shaketheappliancetorinsetheentiresteam
generator,thenthrowthewateraway.
• Screwthecapbackon,makingsureitclo-
sesthesteamgeneratorefciently.
• ReplacetheprotectivecapF.
Before resuming ironing, discharge steam
into the air for a few seconds to completely
eliminate any residues from the internal cir-
cuits.
Important!
If the lter cannot be regenerated or replaced,
proceed as follows:
• Useacointoturnthewaterhardnessregu-
lator Ltothepositioncorrespondingtovery
hardwater(irrespectiveoftheresultsobtai-
ned using the indicator paper).
• Whenthe FILTERlightcomeson,rinsethe
steamgeneratorasdescribedabove.
• Afterrinsing,pressthe RESETbutton.
CLEANING
• Thesurfaceoftheplatemustbekeptclean.
To clean, just wipe the cold surface with a
damp cloth.
• Theironmustneverbetreatedwithdesca-
ling products.
AFTER IRONING
Afternishing ironing, you shouldput the iro-
ning system away with the door tightly closed
toavoiddustandforeignbodiesfallingintothe
tankandpossiblyjeopardisingoperationofthe
pump.
Place the iron on the iron rest (in the secured
position for models with domestic iron) and wait
for the system to cool down before putting it
away.
Toputtheapplianceawaytidily,xthesteam/ca-
bletubetothehookFandwindthepowercable