Delta Children 35201-270 User manual

Customer Service: 1-(800)-377-3777 www.DeltaChildren.com
Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE.
35201-270
Required Tools: 4 "AA" Batteries (Not included), Screwdriver (Not included)
INSTRUCTION MANUAL
DCP IM 11-20-2017
WARNING:
Adult assembly required because of
small parts. Keep assembly parts
out
of reach of children under 3 years.
CHOKING HAZARD
Styles and colors may vary
Play Time
Rocking Bassinet

Delta Childrens Products Corp.
114 West 26th Street
New York, NY 10001
1-800-377-3777
www.deltachildren.com

3
Customer Service Tel. [phone] www.DeltaChildren.com
Frame
Mattress Pad Cross Tubes -2Mattress Support
Storage Basket
Sheet
M5 X 2.6cm Screw -2
M6 x 4cm Screw – 8
M5 2.7cm Pre-installed Screw in Music Box-2
Canopy Legs -2
Base with Wheels - 2 Liner
Parts
IMPORTANT! Please remove all parts from the package and identify them before assembly.
Wrench Screwdriver
Shown Actual Size
M5 Lock Nut – 2 M6 Lock Nut – 4

4
Customer Service Tel. [phone] www.DeltaChildren.com
Bassinet Assembly
Note: You may need the help of another adult to help steady all parts for
assembly.
• Place a base on a flat surface with the slots facing up.
• Fit a cross tube into each slot. Push down on each tube to be sure it
is in place.
• Position the storage basket so that the pockets face away from you.
• Slide the storage basket fabric sleeves onto the cross tubes.
Cross Tubes
Slots
Base
Storage Basket
Tunnels
1
2

5
Customer Service Tel. [phone] www.DeltaChildren.com
Bassinet Assembly
• Fill the other base slots onto the cross tubes. Push on the base near
each cross tube to be sure it is in place.
• Insert an M6 x 4cm screw through the hole in each base, the ends of the legs and into
the end of each cross tube.
Hint: You may need to align the holes of all three parts to properly insert the screw.
• Tighten the screw with the Phillips screwdriver.
• Repeat this procedure to fasten the legs, bases and cross tubes on the
other side of the assembly.
• First, fit the ends of a leg into short fabric sleeves in the storage basket.
• Then, fit the ends of the leg into receptacle in each base.
• Repeat this procedure to assemble the other leg to the storage basket
and bases.
Cross Tubes
Base
Legs
Short Tunnels
Receptacles
Base
M6 x 4cm Screws
3
4
5

6
Customer Service Tel. [phone] www.DeltaChildren.com
Bassinet Assembly
• Turn the assembly upright.
• Check to be sure the legs are secure. While gently holding the base
down, pull up on the legs. They should remain assembled to the bases.
• Rotate the bases of the frame down.
• Place the frame onto the top of the legs. Align the holes in the bases
of the frame with the holes in the legs.
Note: Do not remove the foam around top of frame.
• Insert four M6 x 4cm screws through the holes in the frame and legs.
• Attach an M6 nut to the end of each screw. Make sure the rounded side
of the lock nuts face down. Hand-tighten the lock nuts onto the screws.
PULL
PULL
Frame
Legs
M6 x 4cm Screws
M6 x 4cm Screws
M6 Lock Nuts M6 Lock Nuts
Rounded Side
6
7
8
9

7
Customer Service Tel. [phone] www.DeltaChildren.com
Bassinet Assembly
• While holding an M6 lock nut in place with the wrench, completely
tighten a screw with the Phillips screwdriver.
• Repeat this procedure tighten the other three screws.
• Check to be sure the frame is secure. While gently holding a base
down, pull up on the frame It should remain attached to the legs.
• Place the mattress support into the frame.
• Check to make sure male snap faces down.
• Align the holes in the mattress support with the holes in the frame.
• Insert tow M5 x 2.6cm screws through the mattress support and into
the frame.
PULL
PULL
Mattress Support
M5 x 2.6cm Screws
10
11
12
13

8
Customer Service Tel. [phone] www.DeltaChildren.com
Bassinet Assembly
• Attached a M5 lock nut to the end of the screw. Make sure the
rounded side of the lock nut faces down. Hand-tighten the lock
nuts onto the screws.
• While holding an M5 lock nut in place with a wrench, completely
tighten screw with a Phillips screwdriver.
• Repeat this procedure to tighten the other screw.
• Locate the mobile attachment mount at the top of the frame.
• Align the mobile attachment icon on the liner with the plastic mobile
attachment mount on the frame.
• Place the liner onto frame. Make sure warning label is centered
at the end of bassinet.
M5 Lock Nuts
Rounded Side
Mobile Arm
Attachment Mount
Liner
Mobile Attachment Icon
14
15
16

9
Customer Service Tel. [phone] www.DeltaChildren.com
Bassinet Assembly
• Lift the skirt on the liner. Snap all 5 straps around the top of the side of
the frame.
• Repeat this procedure to snap the other 5 straps around the top of the
frame.
• Stretch the pockets on the bottom of the liner around the ends of the
mattress support.
• Snap both straps on the bottom of the liner to the bottom of the
mattress support.
Note: Snaps do not go over metal tube.
• Repeat this procedure to snap the other two straps on the bottom of the
liner to the mattress support.
• Place the sheet over the mattress pad.
• Place the mattress pad with sheet into the liner.
Snaps
Snap
Mattress Support
Mattress Support
Pocket
Pocket
Snaps
Mattress Pad with Sheet
17
18
19

10
Customer Service Tel. [phone] www.DeltaChildren.com
Bassinet Assembly
• Position the canopy over the top end of the bassinet opposite the
warning label.
• Open the hook and loop fasteners on the liner and push aside foam to
expose metal.
• Push the canopy ratchet onto the frame on both sides of the bassinet.
• Fasten the hook and loop fasteners on the back edge of the canopy to the liner.
• Fasten the hook and loop patches on each canopy flap to the side of
the liner.
Canopy
Ratchet
Frame
Hook and Loop
Fasteners
Snap
Snap
20
21
22