Delta Children Jeep Safety Gate User manual

Jeep®Safety Gate Owner’s Manual
KEEP FOR FUTURE REFERENCE
Please read the instructions carefully
before installing this gate.

Important Information
Children have died or been seriously injured when gates are not
securely installed.
• ALWAYS install and use gate as directed using all required parts.
• STOP using when a child can climb over or dislodge the gate.
• Use only with latching mechanism securely engaged.
• NEVER use a gate to keep child away from pool.
• To prevent falls, NEVER use at top of stairs.
WARNING:
CAUTION:
COLORS AND STYLE MAY VARY.
This product contains small parts which are for adult assembly only.
Keep assembly parts out of reach of children under 3 years.
ADULT ASSEMBLY REQUIRED.
2
DISCLAIMERS
Any misuse, abuse, abnormal use, excessive wear and tear, improper assembly, negligence, environmental
exposure, accident or alteration of the gate, as well as removal or alteration of its serial number, invalidates
any and all claims against the manufacturer. Any damage to property during installation is the sole
responsibility of the end user.
PLEASE NOTE: There is a gap between your gate frame and handle.
This is not a defect. This gap will close once your gate is properly installed.
Please check the gate on a regular basis to ensure that all parts
are in proper working condition.
Please inspect your gate immediately.
If you see any damage, do not attempt installation.

Getting Started
MEASURE DOOR OPENING
Choose location for gate and measure opening. Use the sizing chart below to choose your configuration.
PARTS
Bottom of Stairs Hallways & Doorways
SIZING
4
Gate (x1) Small
Extension (x1)
Large
Extension (x1)
PLEASE NOTE:
The gate must be installed between two structurally sound surfaces. Do not use 2 extensions on same side of gate.
Both Extensions
38.5”- 42”
Wrench (x1)
Extension Pins (x4)
Spindles (x4)
1
1
2
3
2 3
Large Extension
34.75”- 38.25”
Small Extension
31.75”- 35.25”
Just Gate
28.5”- 33”

Extensions: Install Spindles: Install 6
Tighten: Turn clockwise Loosen: Turn counter-clockwise
2
1Insert Pins 1Insert Spindles
PARTS
NEEDED:
PARTS
NEEDED:
3

Gate: Install 8
Tighten top 2 spindles
5
PARTS
NEEDED:
Before tightening
handle needs to
be opened.
TIGHTEN
EQUALLY
ON
ALL SIDES
6Continue tightening on both sides
until the handle just touches
opposing post
7Loosen top spindle closest
to handle by 2 turns
Push handle down to lock and
install complete
8
Place gate in center
of doorway in the
direction of opening
1
Tighten bottom
2 spindles equally
4
Pull back handle
and hold
2
Pivot handle up
3
Gate
Floor

Use 10
TO OPEN TO CLOSE
3Lift gate door up until the swing lock disengages
Pull back handle
1Pivot handle up 2
Open door
4
Handle up, return
gate to closed
position
1 2 Make sure swing lock is engaged
4
Push handle down to lock
3
PLEASE NOTE: Always check the handle
to make sure that the gate is securely locked
and never leave your child unattended

PRODUCT AND DESIGN ARE TM & ©2019 DELTA CHILDREN, INC.
114 W 26TH ST, NEW YORK, NY 10001.
HTTP://WWW.DELTACHILDREN.COM.
MADE IN CHINA/FABRIQUÉ EN CHINE.
CLEANING YOUR GATE
Use mild soap and wipe with a damp cloth. Be careful NOT to wash or wipe the stickers on the base of the gate.
Removing or damaging the stickers will void the warranty.