Delta Premium PS1003 User manual

Assembly instructions
Assembled Shelving Kit
with Shelves*
(Not included with all sets)
Premium
Shelving Kit
x2 — Aluminum Slotted Upright
x4 — Cosmetic Cover
x4 — Upright End Caps
x4 — Arms* (x6 PS1003)
x4 — Arm End Caps* (x6 PS1003)
x8 — Wall Screws
x8 — Shelf Screw* (x12 PS1003)
x8 — Drywall Anchors
x1 — Connector Alignment Piece
x2 — Shelf* (Not included with all sets)
Parts
A
B
C
D
E
F
G
H
I
J
Assembly video
Visit designbydelta.com/downloads
Place uprights against located stud on wall and
mark location for holes. Use a spirit level to make
sure it is vertically aligned. Ensure second upright
is horizontally aligned and level with the rst upright,
when marking locations for holes. Drill 1/8" (3mm)
pilot holes. Then secure the uprights to wall using
screws provided.
1
NOTE: If mounting to a drywall, use the included
drywall anchors (Part H). Drywall anchors require
5/16" (8mm) pilot holes. Once holes are drilled
gently tap drywall anchors into place, then secure
uprights using screws provided.
IMPORTANT SAFETY NOTE
Beware of drilling into electrical wire
or pipes within wall!
WALLBOARD
STUD
STUD
CENTERLINE
WARNING
Do not allow children to play or hang from Shelving Kit.
Maximum weight 18 kg (40 lbs) per shelf arm, evenly distributed on properly installed rack into studs.
Installing into a drywall will reduce the weight capacity
Way of locating studs within the wall (see hardware store for advice)
Tools Required
Hand Drill
1/8" (3mm) drill bit for attaching to wood studs
5/16" (8mm) drill bit for attaching to
concrete walls
Magnetic Phillips Drill Bit
Tape Measure
Spirit Level
*Installing into wood studs is the recommended
method.
16"
A
B
C
D
E
F
G
I
J
H

Service: Please do not return to store;
for immediate response email
[e-mail]
Delta Cycle Corporation
36 York Avenue, Randolph, MA 02368 USA
800-474-6615 / www.designbydelta.com
2
Choose desired positions for arms (Part D).
Insert into place, by hooking into slot.
3
Use scissors or utility knife to cut cosmetic cover (Part B)
to the determined height and insert into upright.
Slide or press the cosmetic pieces into the groove at the
front of the upright.
4
Assemble shelves (Part J)*
using shelf screws (Part G)*
5
Assemble upright end caps (Part C)
to uprights. (FIGURE 1)
Assemble arm end caps (Part E)
to arms. (FIGURE 2)
When aligning multiple racks vertically, use the included
connector alignment piece (Part I). First, slide the lower
half of the connector alignment piece into the lower
upright. Then slide the upper upright onto the top half of
the connector alignment piece.
Expandable Option
Once position is conrmed,
measure the distance above,
between and below each arm.
This will give you the size for
cosmetic cover. (FIGURE 1)
FIGURE 1
ABOVE
BETWEEN
BELOW
FIGURE 1
092322
FIGURE 2