Delta 34-868 User manual

422-04-655-0053 - 10-17-02
INSTALLING 34-868 SPLITTER
ASSEMBLY
INTRODUCTION
IMPORTANT: The following instructions for installing
the splitter are shown on a Delta 10" right-tilting arbor
Unisaw.
Fig. 2
Fig. 3
Fig. 1
ASSEMBLY
1. Locate the following components shown in Fig.1, for
the splitter assembly.
A. Splitter
B. 5/16 - 18 x 5/8" button head screws (2)
DISCONNECT MACHINE FROM
POWER SOURCE.
2. Remove the saw blade from the saw arbor and
remove the standard splitter assembly, including mount-
ing brackets, from the saw as shown in Fig. 2.
DO NOT USE THIS MACHINE WITH-
OUT A BLADE GUARD. AN OVERARM TYPE GUARD
SYSTEM IS RECOMMEND TO BE USED WITH THIS
SPLITTER ASSEMBLY.
3. Assemble the splitter (A) Fig. 3, to the inside of rear
trunnion using two button head screws (B), and hex
wrench (C). NOTE: Do not completely tighten the button
head screws at this time.
4. Using a straight edge (S) Fig. 4, align the splitter (A) to
saw arbor (B) as shown. Then tighten two screws assem-
bled in step 3.
A
B
A
B
Fig. 4
B
S
A
1
C

2
5. To position the splitter for use, lift up on the slide bar
as shown in (B) Fig. 5, and then release.
Fig. 5
BLADE GUARD ACCESSORIES
Deluxe Uniguard®Blade Guard
The Delta Model 34-976 Uniguard Blade Guard Fig. 6, is
an accessory that can be used in place of the standard
blade guard. The Delta Model 34-976 Uniguard Blade
Guard can be mounted with a UniRip or Unifence, fence
systems.
78-953 Uniguard Strap Kit. Kit replaces the rear angle
rail of Biesemeyer 30" and 50" Commercial Fence
Systems and Home Shop Fence Systems up to 52" for
mounting the No. 34-976 Delta Uniguard Blade Guard.
Fig. 6
Biesemeyer®T-Square®Table
Saw Blade Guard System
The Biesemeyer Model 78-960 T-Square Table Saw
Blade Guard System Fig. 7, is an accessory that can be
used in place of the standard blade guard.
78-960 10" System for Home Shop 52" and Commercial
50" Fence Systems.
78-955 10" System for Home Shop 28", 40" and
Commercial 26", 30" and 38" Fence Systems. Same as
78-960 except for fence systems 40" and under.
Fig. 7
B
DO NOT USE THIS MACHINE WITHOUT A BLADE GUARD. AN OVERARM
TYPE GUARD SYSTEM IS RECOMMEND TO BE USED WITH THIS SPLITTER ASSEMBLY.
SOME TYPES OF OVERARM BLADE GUARD SYSTEMS ARE SHOWN BELOW AND ARE
AVAILABLE FROM DELTA. OTHER BRANDS SIMILAR TO THESE CAN ALSO BE USED.