Denali MA11110 User manual

866.527.7637 1 [e-mail]
DENALI Plow Mount
MA11110
Polaris Sportsman
Thank you for purchasing our DENALI plow mount. You now own a premium custom
plow mount to allow you to use your plow with your ATV. Please note the following
instructions and heed all warnings.
•Your ATV and/or plow system can cause death or injury, please use caution and
common sense when operating your unit.
•Read your Plow Operator Manual, your Winch Operator Manual, and all warning
labels before operating your ATV.
•Operate your ATV at a walking speed with the blade installed. Do not exceed 5
mph (8 km/h), even with the blade up.
•Do not operate the ATV on slopes greater than 10 degrees with the plow
installed.
•Always lower the plow to the down position before leaving your ATV unattended.
SEVERE INJURY OR DEATH MAY RESULT IF YOU ARE NEGLIGENT.

Polaris Sportsman
MA11110 22000 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 2 [e-mail]
Please verify that all hardware and parts are included in your package.
Kit Contents:
Item Number
Description
Quantity
1
Base Plate
1
2
MA11110 Rear Strap
1
3
2 ¼” Serrated Hex Bolt (92323A563)
1
4
3/8” x 1” Serrated Hex Bolt (92323A554)
4
5
3/8” Serrated Flange Nut (95922A130)
5

Polaris Sportsman
MA11110 22000 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 3 [e-mail]
Plow Mount Assembly:
1. Insert the Rear Strap over the Sportsman 1000 frame, just behind the Drive Shaft U-
Joints as shown in Figure 2. Orient the Rear Strap so that the angled bends match
the angles of the frame. It may be necessary to remove one of the plastic fender
clips on the right hand side of the vehicle to maneuver the Rear Strap into position.
Once the Rear Strap is positioned, replace the plastic clip.
Figure 2

Polaris Sportsman
MA11110 22000 Industrial Blvd
Rogers, MN 55374
866.527.7637
866.527.7637 4 [e-mail]
2. Hold the Plow Base Plate up to the Rear Strap to align all five bolt holes. Insert the
3/8’’ x 2-1/4’’ Serrated Flange Bolt into the middle hole at the top of the Rear Strap.
Install one of the 3/8’’ Serrated Flange Nuts but do not tighten at this time.
3. Install the remaining four 3/8’’ x 1’’ Serrated Flange Bolts from the top of the Rear
Strap, secure with the remaining four 3/8’’ Serrated Flange Nuts. Tighten all the
bolts at this time.
4. Install the plow mount per the manufacturer’s instructions.