Denver SWC-363 User manual

SWC-363
denver.eu
À DÉPOSER
EN MAGASIN À DÉPOSER EN DÉCHÈTERIE
OU
FRFR
Cet appareil et
ses accessoires
sont recyclables
06/22

Caution: When the first time you use the fitness tracker,
please make sure to fully charge it before using. Please
read this user guide carefully before using the product.
It contains important information for your safety as well
as use and maintenance advice. Keep this user guide for
future reference.
Getting Started
ENG-1
The product contains electrical components that could
cause injury if not handled properly.
·Do not open the enclosure or disassemble the product.
·Do not expose the product to extremely high or low
temperatures.
·Do not use the product in a sauna or steam room.
·Do not leave the product in direct sunlight for an
extended period of time.
·Do not dispose the product in a fire, the built-in battery
can explode.
·The product features a built-in battery, which is not user
replaceable.
·Do not check call notifications or other data on the
product's screen while driving or in other situations
where distractions could be hazardous.
·The distance travelled may be inaccurate. It is for
reference only and should not be used as any
navigational reference.
·The product should usually rest a finger's width below
the wrist bone, as you would normally wear a bracelet.
·This product has been classified as lP67 daily waterproof.
Safety Precautions

ENG-2
Caution: The device may cause skin irritation. Prolonged
contact may contribute to skin irritation or allergies in
some users. If you notice any signs of skin redness,
swelling, itchiness or other skin irritation, please
discontinue using the product. Continued use, even after
symptoms subside, may result in renewed or increased
irritation. If symptoms persist, consult your doctor. Do
not open the enclosure or disassemble the product.
Blood Oxygen Notice
·WARNING! Only a medical practitioner is qualified to
interpret your blood oxygen measurements. The use of
this smart bracelet should not replace regular medical
examinations.
·Blood Oxygen can be subjected to wide fluctuations in
a short period of time. Its level depends on many factors.
·Different medicines, alcohol and smoking can exert a
large influence on the level of Blood Oxygen. Do not
smoke, drink caffeinated beverages or exercise within
the 30 minutes before measuring your blood oxygen.
Intended Use
This smart bracelet is intended for monitoring fitness-
related metrics such as heart rate, blood pressure,
distance walked or run, calorie consumption and quality
of sleep. Data measured should not be used for any
medical, ambulatory or dietary reference.

Product Overview
Power-on
Press and hold the side button for 3 seconds or plug in
the magnetic charging cable to charge the smart watch.
ENG-3
Charging
contacts
Heart rate
monitor

Download and connect with
smart watch App
1. Download and install App.
· Scan the QR code with your phone to download the
App.
· iOS system: search and download “Da Fit” from App
Store.
· Android system: search and download “Da Fit” from
Google Play.
Da Fit
Note: your mobile phone must support Android 5.1 or
IOS 8.0 or above, and Bluetooth 4.0 or above.
ENG-4

2. Connect smart watch with App.
1.Click "Add Device" to
find the smart watch.
ENG-5
2.Click on your device in
the device list scanned.
SWC-363

3. The iOS system will
show a Bluetooth pairing
request and you can click
"Pair" to confirm.
Android system connects
with your watch directly.
SWC-363
“SWC-363”would like to pair with
your iPhone.
Bluetooth Pairing Request
4.Successfully bound.
ENG-6
SWC-363

Bluetooth call connection
Android phone:
1. After the App successfully connects to the watch's
Bluetooth, your phone will automatically pop up a
"pairing" request, click "Allow".
2. Some mobile phone models don’t need a pairing
confirmation. After connecting the watch with App,
the Bluetooth connection for call function is also
established. Then you can answer and make calls on
the watch.
iOS phone: Go to Settings > Bluetooth, search for the
device SWC-363 and pair with it. After the devices are
connected successfully, you can make and answer calls
from your watch.
Remove Bluetooth call connection
Android phone: The device can be disconnected from
your mobile phone by simply clicking on “Remove device”.
iOS phone: Go to Settings > Bluetooth, select SWC-363,
then click “Forget This Device”, your watch and mobile
phone are now disconnected.
ENG-7

Smart watch functions
Swipe the touchscreen to switch the menu interface
and access the various features of the watch. The
interfaces are shown below:
ENG-8

Remove the device
For Android phones, the device can be disconnected
from your mobile phone by simply clicking “Remove
device”.
For iOS phones, after binding removal from the App, go
to Settings > Bluetooth, then click “Forget This Device”.
ENG-9
SWC-363
12

SWC-363 SWC-363
34
ENG-10

ENG-11
Frequently Asked Questions (FAQs)
1. Why does the smart watch automatically
disconnect Bluetooth when the Android
phone’s screen is locked?
1 > Lock background App. When the Da Fit process is
cleared, the smart watch will be disconnected from
the mobile phone.
2 > Allow App self-startup.
3 > Allow unrestricted background operation. The
Android mobile phone intelligently restricts the
background operation of Apps by default. Users need
to manually allow the App to run in the background.
2. Why can’t the smart watch receive
message push?
1 > Please confirm that you have turned on the switch for
message push in notification on mobile phone.
2 > Please confirm that messages can be displayed
normally in the mobile phone notification bar. The
message push on the smart watch is gone after you
read the message from the mobile phone notification
bar. The smart watch will not receive the message
push if there is no message in the mobile phone
notification bar. (You need to find notification settings
in the mobile phone settings, and turn on the
notification switch for WeChat, QQ, call, SMS and
others.

3 > Go to settings on your mobile phone. Write
“Notification use" in the search box, close settings
and re-open Da Fit.
3. Can I wear the smart watch in a bath,
sauna or hot tub?
No. The bath water has a relatively high temperature
and generates a lot of vapor which is in the gas state
with small molecular radius and can easily infiltrate into
the smart watch from the shell gap. When the
temperature drops down, the vapor will condense into
liquid droplets which can easily cause short circuit and
thus damage the smart watch.
Warning:
Please consult your doctor before starting a new exercise
program. The smart watch should not be used for any
medical purpose though it may dynamically monitor
the heart rate in real time.
ENG-12

ENG-13
Please notice - All products are subject to change
without any notice. We take reservations for errors and
omissions in the manual.
ALL RIGHTS RESERVED, COPYRIGHT DENVER A/S
denver.eu
Electric and electronic equipment and included batteries
contains materials, components and substances that can
be hazardous to your health and the environment, if the
waste material (discarded electric and electronic
equipment and batteries) is not handled correctly.
Electric and electronic equipment and batteries is marked
with the crossed out trash can symbol, seen above. This
symbol signifies that electric and electronic equipment
and batteries should not be disposed of with other
household waste, but should be disposed of separately.
As the end user it is important that you submit your used
batteries to the appropriate and designated facility. In
this manner you make sure that the batteries are recycled
in accordance with legislature and will not harm the
environment.

ENG-14
All cities have established collection points, where electric
and electronic equipment and batteries can either be
submitted free of charge at recycling stations and other
collection sites, or be collected from the households.
Additional information is available at the technical
department of your city.
Hereby, Denver A/S declares that the radio equipment
type SWC-363 is in compliance with Directive 2014/53/
EU. The full text of the EU declaration of conformity is
available at the following internet address: denver.eu
and then click the search ICON on topline of website.
Write model number: SWC-363. Now enter product
page, and RED directive is found under downloads/other
downloads.
Operating Frequency Range:2402MHZ-2480MHZ
Max Output Power:4.2W
DENVER A/S
Omega 5A, Soeften
DK-8382 Hinnerup
Denmark
www.facebook.com/denver.eu

Contact
Nordics
Headquarter
Denver A/S
Omega 5A, Soeften
DK-8382 Hinnerup
Denmark
Phone [phone]
(Push “2” for support)
E-Mail
For technical questions,
please write to:
[e-mail]
For all other questions
please write to:
[e-mail]
Germany
Denver Germany GmbH Service
Gutenbergstrasse 1
94036 Passau
Phone [phone]
E-Mail [e-mail]
Fairfixx GmbH
Repair and service
Rudolf-Diesel-Str. 3 TOR 2
53859 Niederkassel
(for TV, E-Mobility/
Hoverboards/
Balanceboards, Smartphones
& Tablets)
Phone [phone]
E-Mail denver@fairfixx.de
Austria
Lurf Premium Service GmbH
Deutschstrasse 1
1230 Wien
Phone [phone]
E-Mail [e-mail]
Benelux/France
Denver BENELUX BV
Barwoutswaarder 13C+D
3449 HE Woerden
The Netherlands
Phone [phone]
E-Mail [e-mail]
Spain
Denver SPAIN S.A.
C/ Moscú, 1 Pol.Ind.Mas de Tous
46185 La Pobla de Vallbona
Valencia (Spain)
Phone [phone]
E-Mail [e-mail]
Portugal
Phone [phone]
E-Mail denver.service@satfiel.com
If your country is not listed above,
please write an email to
[e-mail]

Denver A/S
Omega 5A, Soeften
DK-8382 Hinnerup
Denmark
denver.eu