Deviceworx Chameleon User manual

Digital Signage
for
Chameleon
Chamleon Player
Quick Start Guide
Follow the simple instructions within this guide to
quickly get your Chameleon set-top player
installed and operating with the Chameleon for
Digital Signage (C4DS) dashboard.
User's Guide Download: www.deviceworx.com
Email Support: [email protected]
Phone Support: 1-888-409-2688
YouTube Ch: Search "Deviceworx Technologies Inc."
Additional Resources

Unboxing
Contents of the player box are shown above. Note that not all
pieces will be used for each install. Installation steps below will
reference each numbered item within boxed contents.
Installation
1. Connect the player to a screen using the HDMI cable (3)
provided. If a DVI connection is required, consult the user's
guide for DVI cable types and options. An HDMI receptacle is
marked on the rear of the player.
2. Use an available Ethernet patch cable to connect the player
"LAN" port to a free Ethernet port on a router, modem, switch
or any other Ethernet networking appliance that supports
Internet browsing. Follow user's guide steps to make a
connection over Wi-Fi (Ethernet is preferred).
3. Connect the player power supply
(2) to the player power receptacle
(marked "DC IN") to start the
player. The player splash screen,
with device ID, will appear on the
display.
4. Access the dashboard by visiting ops.deviceworx.com using a
web browser and select the Chameleon dashboard link. A login
page will be shown as below. Enter your Account, Username
and Password to gain access to the dashboard.
5. After login, the dashboard will show a player Device list. This
list should include the new player with its matching ID.
6. To configure advertising playback, select the Ad Manager tab.
Press "Select" to choose a local advertising graphic file (PNG or
JPG) for display. Enter an Ad Name.
7. Press "Upload and Save" to transfer the file to the dashboard.

8. Select "Simple Campaigns" within the Ad Manager. Enter a
Campaign Name and Description similar to the example below
and press "Save". The "Test" Ad created in step 6 will then
show up as a Candidate Ad. Press to add "Test" to the
campaign and press "Save" again to update the campaign.
9. Select "Device" to show the listed player. Click on the player to
configure it. Select the "Test Campaign" and then press "Save".
10. Wait 2 minutes or less for a player configuration update. Ad
playback will start automatically with default fade in/out
animation.