DHK Hobby RAZ-R BL Operator's manual

Part# Desc
8381-100
Assembly of diff gear box
8381-101 Diff set
8381-102 Diff outdrive/pins (dia 2*10mm)
8381-103 Pins(dia 2*10mm) (16 pcs)
8381-104 Flathead screw -coarse thread(KB2.6*10mm)
(16 pcs)
8381-105 Crow n gear-41T (large)/pinion gear-11T
(small)
8381-106 Diff case set/diff case cover/diff gasket
8381-107 Washer-A/w asher-B (8 pcs each)
8381-108 Gear-18T (2 pcs)/gear-12T (4 pcs)
8381-109 O Ring(dia 8mm*dia 2mm) (16 pcs)
8381-110 Ball bearing(dia 10mm*dia 15*4mm) (2 pcs)
8381-111 Diff pins(dia 4*25.8mm) (4 pcs)
8381-112 Assembly of the pinion gear
8381-113 Flathead screw (KM2.6X6mm) (16 pcs)
8381-114 Ball bearing(dia 8mm*dia14*4mm) (2 pcs)
8381-115 Pins(dia 2*8mm) (16 pcs)
8381-116 Pinion gear outdrive/pins(dia 2*8mm)
8381-117 Ball bearing(dia 5mm*dia 11*4mm) (2 pcs)
8381-118 Diff gear box-F/R
8381-119 B head screw -coarse thread(BB3*16mm) (16
pcs)
8131-200 Diff box assembly
8131-201 Diff outdrive/pins (dia 2*10mm)
8131-202 Brackets (2 pcs)
8131-203 Diff gear box (diff gear cover upper/low er)
8131-204 Spur gear-53T (plastic) (2 pcs)
8131-205 Center diff outdrive/lock nut(M4*4mm)
8381-204 Set screw s (M4*4mm) (16 pcs)
8131-300 Shock absorber complete (2 PCS)
8131-301 Shock spring (4 pcs)
8381-305 Shock ball (8 pcs)
8381-306 M3 nylon nut (8 pcs)
8381-309 Shock shaft (4 pcs)
8381-400 Anti-roll bar assembly
8381-40L Assembly of anti-roll bar linkage-left
8381-40R Assembly of anti-roll bar linkage-right
8381-401 Anti-roll bar rod end (8 pcs)
Part# Desc
8381-402
Anti-roll bar linkage (4 pcs)
8381-403 Anti-roll bar pivot ball-upper/low er (4 sets)
8381-404 Set screw s (M3*3mm) (8 pcs)
8381-405 Anti-roll bar(dia 2.2mm) (2 pcs)
8131-50L Assembly of upper sus.arm-Left
8131-50R Assembly of upper sus.arm-Right
8131-501 Upper sus.arm/rod end (2 sets)
8131-502 Upper sus.arm linkage (2 pcs)
8381-501 Upper sus.arm ball (4 pcs)
8131-600 Servo saver assembly-complete
8131-601 Servo saver spring (4 pcs)
8131-602 Steering plate
8381-601 Brass w asher (4 pcs)
8381-602 Servo saver bushing/adjustment ring
8381-604 Servo saver sus. Arm-upper/low er/steering
sus. Arm
8381-605 B head screw -coarse thread(BB3*12mm) (16
pcs)
8381-606 Screw bushing (16 pcs)
8381-608 Shaft (2 pcs)
8131-6Z0 Assembly of steering linkage (2PCS)
8381-6Z2 Plastic rod end (8 pcs)
8381-6Z3 Double w ay ball end (8 pcs)
8131-701 Low er sus.arm-front (2 pcs)
8131-702 Drive shaft set-A (2 pcs)
8131-703 Wheel axle (2 pcs)
8131-704 T head screw (TM4*17mm) (16 pcs)
8131-705 Steering arm (2 pcs)
8131-706 Hex adaptor (4 pcs)/12mm nut
8131-707 M6 lock nut (4 pcs)
8381-701 Upper sus.arm mount-rear/suspension mount
8381-702 B head screw -coarse thread(BB3*14mm) (16
pcs)
8381-703 B head screw -coarse thread(BB3*10mm) (16
pcs)
8381-710 Ball bearing(dia 6mm * dia 12*4mm) (2 pcs)
8381-715 B head screw (BM3*20mm) (16 pcs)
8381-716 Set screw s (M4*10mm) (16 pcs)

Part# Desc
8381-717
Shock tow er (2 pcs)
8381-718 Pivot ball mount (4 pcs)
8381-719 Upper sus.arm shaft (4 pcs)
8381-720 Front bumper/upper sus.arm mount-front
8381-721 Low er sus.arm plate-front
8381-726 B head screw -coarse thread(BB3*18mm) (16
pcs)
8381-727 B head screw (BM3*56mm) (8 pcs)
8131-801 Low er sus.arm-rear (2 pcs)
8131-802 Sus.arm short axle (4 pcs)
8131-803 Rear hub-L/R
8131-804 Rear w ing (black)
8381-803 B head screw (BM3*18mm) (16 pcs)
8381-804 Wing mount/w ing brace-L/R
8381-805 B head screw (BM3*10mm) (16 pcs)
8381-806 Rear w ing rod-long/short
8381-807 Pin-A(dia 1.5mm) (16 pcs)
8131-9S1 Servo mount
8381-9S2 Servo arm (2 pcs)
8381-9S3 B head screw (BM3*6mm) (16 pcs)
8381-9Z0 Assembly of steering tie rod
8381-9Z1 Steering tie rod (2 pcs)
8131-9M1 Motor mount
8131-001 Chassis
8131-002 Upper deck mount-F/R
8131-003 Central drive shaft-E
8131-004 Battery mount-A/B
8131-005 Receiver cover-upper/low er
8131-006 Upper deck-F
8131-007 Upper deck-G
8131-008 Wire mount (2 pcs)
8382-005 Central drive shaft-C
8381-008 Antenna tube (3pcs)
8381-009 Pin-B(dia 1.2mm) (16 pcs)
8381-010 Screw w asher(4 pcs)
8381-011 Flathead screw (KM3X10mm) (16 pcs)
8381-012 Flathead screw -coarse thread(KB3*10mm) (16
pcs)
Part# Desc
8381-014
Flathead screw (KM3*5mm) (16 pcs)
8381-015 Flathead screw (KM3X18mm) (16 pcs)
H108 Brushless ESC (35A)
H109 3650 Brushless motor (KV:3970)
H110 LiPo battery (7.4V, 20C, 2300mAh)
D302T 2.4GHz transmitter
D302S 2.4GHz receiver
Remarks: all the above parts are applicable for both
RAZ-R BL & Wolf BL.
The following parts are suitable for cars only
where there are √
8131-9M2
Motor gear-18T/Lock nut(M3*3) √
8132-9M1 Motor gear-15T/Lock nut(M3*3) √
8131-009 Body post-F/R √
8131-010 Rear tires (for buggy 8131) √
8131-013 Front tires (for buggy 8131) √
8131-011 Painted body (for buggy 8131)
(PVC body) √
8131-011C Clear buggy body (PVC, with
window cutout and body decals √
8131-015 Buggy front w heels (2 pcs) √
8131-016 Buggy front tires (w ith foams)-
unglued (2 sets) √
8131-017 Buggy rear w heels (2 pcs) √
8131-018 Buggy rear tires (w ith foams)-
unglued (2 sets) √
8132-001 Tires (for truggy 8132) √
8132-002 Painted body (for truggy 8132)
(PVC body) √
8132-002C Clear truggy body (PVC, with
window cutout and body decals) √
8132-003 Body post holder/body post √
8132-005 Truggy w heels (2 pcs) √
8132-006 Truggy tires (w ith foams)-unglued
(2 sets) √
8382-705 B head screw (BM3*24mm) (16
pcs) √
D303 Servo (6kg, for truggy 8132) √
D304 Servo (3kg for buggy 8131) √
Optional parts
8131-012 Side guard (left/right) & aluminium chassis
D302HT 2.4GHz LCD transmitter
P102 Smart multi-functional charger & discharger
P103 LiPo battery (7.4V, 30C, 3200mAh)
8131
8132

Servo saver assembly
-complete

Servo saver
bushing/adjustment ring
Hex adaptor (4 pcs)/12mm nut M6 lock nut (4 pcs)

(4 pcs)
D302T 2.4GHz transmitter
D302S
8131-011C Clear buggy body
(PVC, with window cutout and
body decals

8131-018 Buggy rear tires
(with foams)-unglued (2 sets)
8132-005 Truggy wheels (2 pcs)
8132-006 Truggy tires
(with foams)-unglued (2 sets)
P102 Smart multi-functional
charger & discharger
Optional parts
8132-002C Clear truggy body
(PVC, with window cutout and
body decals)
8131-013 Front tires
(for buggy 8131)