Diaz PL 11 User manual

Diaz PL 11 / PLK 13 / PLE 12 with mounting prole
www.diaz.be 1
V.22.00
prole stabilizer (PLK 13 - PLE 12
(position should be under or
nearby the clip).
Content
Placement of the clips on the profile
Manual
PL 11 - PLK 13 - PLE 12
with mounting prole
clip
sliding block
mounting angle
pleated blind PL 11
pleated blind PLK 13 - PLE 12
mounting support
mounting prole
Make sure that the distance between the clip and the end of the pleated blinds is 50 or 65 mm.
50 mm
50 mm
max. 600 mm
top prole PLK 13 - PLE 12
bottom prole PL 11 - PLK 13 - PLE 12
+ top prole PL 11
65 mm
max. 600 mm
max. 600 mm
65 mm
Don’t place
brackets here
Attention! Make sure the brackets
are not xed on top of the spools
in the headrail.

Diaz PL 11 / PLK 13 / PLE 12 with mounting prole
www.diaz.be 2
V.22.00
Please ensure that there is a gap of at
least 100 mm between the pleated blind
and the glass pane to ensure sufcient
ventilation. Furthermore, allowance
should be made for ventilation gaps.
If the air circulation is inadequate, this
may lead to heat accumulation and the
formation of condensation. We cannot
accept any liability for damage to fabric
caused by drip water or insect excrement.
Attach the mounting prole to the mounting support or mounting angle.
Insert the prole in the bottom edge of the clip
and press it upwards (untill it clicks).
Add the sliding blocks to the mounting prole.
Use the screw to t the sliding block into the mounting prole.
2
4
3
CLICK
Mounting of the pleated blind
Mount the mounting support or mounting angle to a at surface.
1
Mounting angle
Mounting
support

Diaz PL 11 / PLK 13 / PLE 12 with mounting prole
www.diaz.be 3
V.22.00
Tension the wire
Operation PL 11
5
1
2
3
4
Cut off the excess cord ends.
Secure the end of the wire by hand or using pliers.
The PL 11 system is opened and closed by moving the operating handle,
using the control rod if necessary.
Release the screw (TX20) slightly (turn anti-clockwise).
Tension the wire (by hand or use pliers).
Tighten the screw (turn clockwise).
For pleated blinds with
more than 1 wire, repeat
steps 1 to 4. Do this before
starting step 5.
TX20

Diaz PL 11 / PLK 13 / PLE 12 with mounting prole
www.diaz.be 4
V.22.00
Operation PLK 13
Operation PLE 12
The PLK 13 system is opened or closed by turning the crank handle.
Attach the crank handle to the crank gear box.
The PLE 12 system is a motorised system.
Consult the electric installation instruction for a correct installation.