Diaz 3854 User manual

Roller blind easy
www.diaz.be 1
V. 20-01
Description of the parts
Installation of the brackets
Installation of the blind onto the brackets
First draw the place of the brackets onto the ceiling or wall. Make sure the brackets
are placed at the exact nished width of the roller blind.
Slide the plastic covers over the screws of the metal brackets (gure 1).
Now hook the roller blind over the edge of the bracket on the operation side (gure 2).
Push the spiral spring on the non operation side (gure 3).
Position the roller blind between the brackets till the blind clicks in the hole of the bracket.
Screw the brackets to the ceiling or wall.
Always make sure that the brackets are
installed in one straight line.
1
1
2
3
4
2
It’s very important that the brackets are
installed at level, when this isn’t the case
the fabric will roll into the brackets.
Manual
Roller blind easy
1
2
3
4
5
1. Plastic end caps
2. Brackets
3. Operation side
4. Operation chain
5. Hem bar
gure 1 gure 3gure 2

Roller blind easy
www.diaz.be 2
V. 20-01
Use a screw driver to push the spiral spring to the inside of the blind. (gure 4)
Slide the roller blind out of the brackets.
By pulling the chain you will pull up and let down the blind. Make sure the fabric isn’t pulled
down lower then the commanded heights, otherwise the fabric will detach from the tube
and will eventually fall off.
1
2
Child safety
User manual
Take down the roller blind
min150cm
gure 4