rollease acmeda SKYLINE BOTTOM UP User manual

Skyline Bottom Up
INSTALLATION MANUAL
SKYLINE BOTTOM UP
INSTALLATION MANUAL
www.shadesbymatiss.com | T. 800 493 2040 | email: [email protected]

CONTENTS
DISCLAIMER
INTRODUCTION
This Installation manual for Skyline Bottom Up has been produced by Rollease Acmeda to supply the necessary information for the safe and correct installation of
Skyline Bottom Up.
DISCLAIMER
Rollease Acmeda has used reasonable care in preparing the information included in this document, but makes no representations or warranties as to the
completeness or accuracy of the information. Information is supplied upon the condition that the persons receiving the information will make their own
determination as to its suitability for their purposes prior to use. Rollease Acmeda assumes no liability whatsoever for any damages incurred by you resulting from
errors in or omissions from the information included herein. Rollease Acmeda reserves the right to make changes without further notice to any products to improve
reliability, function or design.
COPYRIGHT
COPYRIGHT © ROLLEASE ACMEDA
All rights are reserved. No part of this document may be reproduced or utilised in any means, by any means, electronic or mechanical including photocopying,
recordings, or by any information storage or retrieval system, without the express permission from Rollease Acmeda.
SECTION A | ITEMS REQUIRED
3
ASSEMBLY PARTS 3
SECTION B | INSTALLATION
4
BRACKETS .............................................................................................................................................................4
TOP ASSEMBLY ......................................................................................................................................................5
BOTTOM ASSEMBLY ..............................................................................................................................................5
COVERS ..................................................................................................................................................................6
SECTION C | TROUBLESHOOTING
7
TROUBLESHOOTING ..............................................................................................................................................7
www.shadesbymatiss.com | T. 800 493 2040 | email: [email protected]

Page. 3
Skyline Bottom Up Installation Manual | October 2018
2018 ©Copyright All Rights Reserved Rollease Acmeda
SECTION A | ITEMS REQUIRED
ASSEMBLY PARTS
1.
1.
2.
2.
2.
2.
3.
7.
3.
3.
6.
3.
5.
4.
SYSTEM INDEX:
1. Skyline Fascia
2. Skyline Bracket
3. Skyline Bracket Cover
4. Top Tube & Control Assembly
5. Bottom Tube & Rail Assembly
6. Skyline Chain Diverter (3” Fascia Brackets only, clutch control option only)
7. Skyline Adaptor
www.shadesbymatiss.com | T. 800 493 2040 | email: [email protected]

WALL MOUNT CEILING/FLOOR MOUNT INSIDE MOUNT
Page. 4 Skyline Bottom Up Installation Manual | October 2018
2018 ©Copyright All Rights Reserved Rollease Acmeda
BRACKETS
STEP 1. - ATTACH BRACKETS TO WALL/CEILING
SECTION B | INSTALLATION
STEP 2. - ENSURE STRAIGHT ALIGNMENT
Ensure brackets are in line.
Shade Width
Shade Drop
Top Bracket
Bottom Bracket
www.shadesbymatiss.com | T. 800 493 2040 | email: [email protected]

INSIDE MOUNT
Use Booster pre-tension tool to pre-tension the Booster with clockwise rotations.
STEP 1. - PRE-TENSION BOOSTER
Page. 5
Skyline Bottom Up Installation Manual | October 2018
2018 ©Copyright All Rights Reserved Rollease Acmeda
STEP 2.  SWING PIN END INTO THE BRACKET
Ensure that the Control hooks are locked to the bracket.
SECTION B | INSTALLATION
STEP 2.  ATTACH BOTTOM ASSEMBLY STEP 3.  ATTACH CORD
Attach bottom assembly to the bottom brackets (spring side
first). Wrench is used to keep tension in the spring while
installing the bottom assembly to brackets.
Attach cord to the spools by tying a knot.
TOP ASSEMBLY
BOTTOM ASSEMBLY
STEP 1.  LOCK CONTROL HOOKS TO THE BRACKET
Swing the Pin End into the bracket.
Knot
Wrench
www.shadesbymatiss.com | T. 800 493 2040 | email: [email protected]

TOP FASCIA
BOTTOM FASCIA
Page. 6 Skyline Bottom Up Installation Manual | October 2018
2018 ©Copyright All Rights Reserved Rollease Acmeda
COVERS
SECTION B | INSTALLATION
STEP 6. - ATTACH FASCIA AND BRACKET COVERS
STEP 5. - ATTACH RAIL SEAL
STEP 4. - ADJUST CORD GUIDES
Adjust the cord guides so that the cords are vertical.
Cut rail seal in 2 places to suit cord location.
www.shadesbymatiss.com | T. 800 493 2040 | email: [email protected]

Page. 7
Skyline Bottom Up Installation Manual | October 2018
2018 ©Copyright All Rights Reserved Rollease Acmeda
PROBLEM CAUSE SOLUTION
1. Fabric roll returns slowly. 1a) Low bottom booster pre-turns
Increase bottom booster pre-turns
1. Lower shade
2. Use pre-tension tool to lock
chainfree control
3. Remove bottom tube
4. Apply additional pre-turns
5. Re-install bottom tube
2. Heavy when raising the weight bar 2a) Bottom Booster Pre-turns too high
Reduce bottom booster pre-turns
1. Lower shade
2. Use pre-tension tool to lock
chainfree control
3. Remove bottom tube
4. Remove pre-turns
5. Re-install bottom tube
2b) Top Booster Pre-turns too low
(if applicable)
Increase top booster pre-turns
1. Lower shade
2. Remove top tube
3. Apply additional pre-turns
4. Re-install top tube
3. Heavy when lowering the shade
3a) Top Booster Pre-turns too high
(if applicable)
Reduce top booster pre-turns
1. Lower shade
2. Remove top tube
3. Remove pre-turns
4. Re-install top tube
4. Poor visual appearance of fabric
4a) Shade tension too low
Increase bottom booster pre-turns
1. Lower shade
2. Use pre-tension tool to lock
chainfree control
3. Remove bottom tube
4. Apply additional pre-turns
5. Re-install bottom tube
4b) Weight bar sagging Move spools & cord guides inwards
(MAX 30% of blind width from edge)
SECTION C | TROUBLESHOOTING
TROUBLESHOOTING
www.shadesbymatiss.com | T. 800 493 2040 | email: [email protected]