Digital Acoustics PNL-CIS4-DA User manual

Page 1of 3
PNL-CIS4-DA
PNL-CIS4-M-DA
PNL-CIS4-M-L-DA
Getting Started Guide

Page 2of 3
Introduction
The PNL-CIS4-DA, PNL-CIS4-M-DA and PNL-CIS4-M-L-DA are vandal resistant analog call station
that incorporate the following options:
Model
Speaker
Call Button
Microphone
LED Call Button
PNL-CIS4-DA
X
X
PNL-CIS4-M-DA
X
X
X
PNL-CIS4-M-L-DA
X
X
X
Specifications
•12 Gauge stainless steel Call Panel
•Integrated 8 Ohm Speaker –waterproof cone
•Integrated security screen to protect the speaker
•Integrated Microphone - water resistant (-M-DA and -M-L-DA)
•Integrated security screens to protect the microphone
•Integrated vandal resistant Call button (-DA, -M-DA)
•Integrated vandal resistant Call button with LED (-M-L-DA)
Installation
Mounting
The PNL-CIS4-x can be flush mounted into a standard 2-gang electrical box or surface mounted in
an optional surface mount box. For outdoor installations, mount under an eave or use a hooded
surface mount box (PNL-BB7).
Wiring Requirements when connecting to the IP7-FX –IP Audio Module
For best results and to minimize interference, connect the Microphone to the IP7-FX with 18-20 AWG
2 conductor SHIELDED wire. Connect the Shield to the J2-4 (GND) on the IP7-FX. Do not connect
the shield to the call station.
Use18 - 20 AWG for Speaker and the Call Button and LED.
If connecting the PNL-CIS4-x to the IP7-FX, the Microphone wire must not be in the same
jacket as the Speaker wire.

Page 3of 3
There is a six-position phoenix style pluggable connector on the back of the PNL-CIS4x:
On the PNL-CIS4-M-L-DA, there are two wires coming off the back of the button to power the LED.
Connect a “current limited”3.3V supply to these two wires (polarity independent) to light the LED.
Connect the pluggable six-position green connector for the PNL-CIS4-M to the IP7-FX as follows:
IP7 and Digital Acoustics® are trademarks of Digital Acoustics LLC.
Other trademarks are the property of their respective owners.
PNL-CIS4-x - 2021-02-08 - All Rights Reserved ©2018
www.digitalacoustics.com/support
Connector
Description
J1-1
Mic +
J1-2
Mic -
J1-3
Ground
J1-4
Talk Button
J1-5
Speaker +
J1-6
Speaker -
PNL-CIS4-x
Connector
IP7 Connector
Comment
J1-1
J2-1 MIC+
Mic Audio
J1-2
J2-2 MIC-
Mic ground
J1-3
J2-4 GND
Ground
J1-4
J2-5 TALK
Talk Button for Call initiation
J1-5
J2-6 SPKR 8Ω+
Speaker Audio
J1-6
J2-7 SPKR 8Ω-
Speaker Audio
LED Wire
J3-5 SNSR/3.3V
3.3V Current Limited - Polarity Independent
LED Wire
J3-6 GND