Digitus DN-95345 User manual

Outdoor 4-Port Fast Ethernet
PoE Switch + 1 Uplink Port
Quick Installation Guide
DN-95345
Introduction
The DIGITUS® outdoor PoE switch is a high quality PoE switch in a
weatherproof housing with the IP67 protection class.The housing is very
sturdy and conforms to the IK10 vandalism protection class. The PoE switch
offers a maximum range of up to 250 meters for PoE 802.3af devices and up
to 200 meters for PoE 802.3at devices with a transmission rate of 10Mbps.
When using the standard 100m range, the transmission rate is 100Mbps.
This outdoor switch serves as an all-in-one device that is ready for use
immediately after connecting it to the mains voltage. The device requires no
settings to be made thanks to plug and play. If you you’re your PoE devices
into a free PoE port, the switch will automatically detect power supply and
PoE mode. The all-in-one solution for outdoor PoE applications requires no
separate power supply and no external overvoltage protection.

Package Contents
* 1x PoE switch * 1x Quick Installation Guide
* 1x T25 L-wrench
Important
1. Install the PoE switch in a ventilated and dry place that is free of
electromagnetic source, vibration, moisture, and dust.
2. Make sure the ventilation openings on the switch are not blocked.
3. Use CAT5 or 5e UTP/STP cables.
4. AC input (100~240V/AC, 50~60Hz), for a max. consumption of 75W.
Connection
Industrial 4xFE PoE + 1xFE EXPoE Switch
VAC 100~240 power input
100
-
240VAC
EX Mo
d
e
OFF
ON
LINK
/
A
C
T PoE
+
- PWR
2 3 4 5

Ex Mode Dip Switch
EX ON Ports 1 & 2 up to 250m PoE distance. When enabled, each port is
isolated, but is linked to the uplink ports.
EX OFF Normal communication for ports 1 ~ 5
EX mode in 802.3af (15.4W):
Camera connection up to 250m@10Mbps via EXPoE ports.
EX mode in 802.3at (30W):
Camera connection up to 200m@10Mbps via EXPoE ports.
Led Definitions
Power Orange ON Power is on and normal.
Orange Off Power is off.
Link/Act Green ON Ethernet port is connected.
Green Off No connection.
Green blinking Data is being transmitted or received.
PoE Orange ON Port is linked to a powered device.
Orange Off No device is connected.
Orange blinking Abnormal power supply is detected.
Port LED1 Port LED2

Installation
Use the included M10 hex socket screws to secure the power box to a pole-mount
or corner mount bracket.
M10
3/4" conduit
a pole-mount or
corner mount bracket.

The mounting hole definition is illustrated below. The same mounting hole pattern
apply to all pole-mount and corner- mount brackets.
Outdoor PoE switch:
DN-95345

Important
1. If the need should arise for connecting two outdoor switches, use the uplink
ports #4 or #5. If you use PoE ports for cross-switch connections, the 12KV surge
protection will not apply.
2. The cabinet must be grounded using a ground wire between the
ground screw and earth ground.

This is a Class A product. In home environment, this product may cause radio interference. In this
case, the user may be required to take appropriate measures.
Hereby Assmann Electronic GmbH, declares that the Declaration of Conformity is part of the
shipping content. If the Declaration of Conformity is missing, you can request it by post under the
below mentioned manufacturer address.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany