DirekTronik EL2315 User manual

EL2315 Dual Rate SFP Media Converter
V2
1
This quick start guide describes how to install and use the Dual Rate SFP media converter. The converter introduced here provides one
channel media conversion solution.
Physical Description
Product Overview
This Dual Rate SFP media converter is a plug-and-play device. Connect the supplied AC to DC power adaptor to the receptacle on the rear panel
of the Dual Rate SFP media converter, and then attach the plug into a standard AC outlet.
DIP Switch
No.
Down
Up
1
Disable LFPT
Enable LFPT
LFPT: Link-Fault-Pass-Through function
2
Enable Auto-Negotiation for TX port
Enable Force mode for TX port
3
TX port Force mode: Full-duplex
TX port Force mode: Half-duplex
4
TX port Force mode: 100Mbps
TX port Force mode: 10Mbps
5
SFP at 100Mbps
SFP at 1000Mbps
6
Function reserved
Function reserved
<Note> Power must be off/on after re-setting LFPT function.
The 10/100/1000Base-TX and SFP Connectors
The 10/100/1000Base-TX Connection
The following lists the pinouts of 10/100/1000Base-TX port.
The SFP Connection
The SFP socket for 100Base and 1000Base fiber optic
expansion.
For SFP expansion

EL2315 Dual Rate SFP Media Converter
V2
2
The Port Status LEDs
LEDs
State
Indication
PWR
Steady
Power on
PWR stands for POWER
Off
Power off
LFPT
Steady
LFPT function enabled
Off
LFPT function disabled
LNKC
Steady
Copper port: A valid network connection established
LNKC stands for LINK/Copper
Off
No connection
G:GE
A:100
Steady
Green: Connection at the speed of 1000Mbps
Amber: Connection at the speed of 100Mbps
Off
Connection at the speed of 10Mbps
LNKF
Steady
Fiber port: A valid network connection established
LNKF stands for LINK/Fiber
Off
No connection
GE
Steady
Force fiber port to 1000Base
Off
Force fiber port to 100Base
Functional Description
Complies with IEEE802.3 10Base-T, IEEE802.3u 100Base-TX/FX, IEEE802.3ab 1000Base-T, and IEEE802.3z 1000Base-SX/LX.
Supports IEEE802.3x Flow control: Flow control for Full-duplex and Back pressure for Half-duplex.
SFP fiber interface supports 100Base and 1000Base dual rate fiber transmission.
DIP switch configuration for “Link-Fault-Pass-Through”.
Gigabit transmission supports 9K Bytes jumbo frame.
1000Mbps-Auto/Full-duplex, 10/100Mbps-Full/Half-duplex, Auto-Negotiation, Auto-MDI/MDIX.
Full wire-speed forwarding rate.
Operating voltage and Max. current consumption: 0.23A @ 12VDC. Power consumption: 2.76W Max.
Power Supply: 12VDC external universal PSU.
0℃to 50℃(32℉to 122℉) operating temperature range.
Aluminum case.
Supports Wall Mounting installation or use with media converter chassis system.
Unpacking
Open the carton and unpack the items. Your package should include an EL2315 media converter and this Quick Install Guide. If items are missing
or damaged, notify your EtherWAN representative Direktronik AB www.direktronik.se
Download the full manual at: https://www.etherwan.com