
Preparatory work
Unpacking and assembling
ᆺCheck that the contents are complete (Fig. 1 ,
Fig. 2 for optional accessories). If you notice any
transport damage or if anything is missing, contact
your dealer immediately. ᆻConnect the appliance
(Fig. 1 /1) to the suction tube (Fig. 1 /2, Fig. 3 ) and
the lower connection piece of the suction tube by
inserting it into the stop catch on the oor nozzle
(Fig. 4 ) so that you hear and feel it click into place.
NOTE:
If you wish to detach the oor nozzle or the suc-
tion tube later, press in the release catch to dis-
engage the components from each other. Then,
pull the components apart.
NOTE:
Place the appliance in a corner of the wall, place
it at on the oor or insert the appliance into the
wall mount (Fig. 8 ) so that it does not topple
over.
Charging the rechargeable battery
WARNING!
Risk of re or explosion! Only use the mains
adapter included in the scope of supply to
charge the rechargeable battery.
ᆺConnect the mains adapter cable to the charging
socket on the appliance (Fig. 5 ). ᆻConnect the
mains adapter to a socket (Fig. 6 ). ᇄThe“ON/OFF”
LED lights up constantly in red to indicate the charg-
ing process (Fig. 7 ). ᆼAfter a maximum of
5.5 hours, the“ON/OFF”LED switches to green.
ᇄThe rechargeable battery is then charged.
ᆽDisconnect the mains adapter from the socket (to
save electricity) and disconnect the mains adapter
cable from the appliance.
Installing the wall mount
ᆺConnect the handle of the appliance to the wall
mount (Fig. 8 ). ᆻPlace the appliance against the
wall, together with the wall mount, so that the oor
nozzle rests at on the oor. ᆼMark the positions for
the drilled holes with a pencil.
ᆽDrill the holes. ᆾRemove the wall mount from the
handle and screw it to the wall with suitable fasten-
ing accessories. ᆿInsert the hole covers.
Switching the appliance on/o
NOTE:
When the“ON/OF” LED (Fig. 7 ) ashes red, the
rechargeable battery charge is low and the ap-
pliance will switch o within 20 seconds. Fully
charge the rechargeable battery to use the appli-
ance again > „Charging the rechargeable battery“
on page 17.
ႧTo switch on the appliance, press and hold the
ON/OFF button on the handle (Fig. 9 /1).
ÎThe motor starts. “ON/OFF” LED lights up
green.
NOTE:
You can lock the ON/OFF button so that the
appliance remains switched on permanently
(Fig. 9 /2). Do not forget to release the locking
mechanism after cleaning.
ႧTo switch o the appliance, release the ON/OFF
button (Fig. 9 /1).
ÎThe appliance switches o. The “ON/OFF” LED
goes out.
Vacuum-cleaning oors or furniture
ᆺFit one of the following nozzles as required if
included in the scope of supply:
NOTE:
The nozzles can also be attached directly to the
connection port on the base appliance.
(Fig. 10+19 ).
• Combo oor nozzle with rotating brush for option-
al activation for hard oors and carpets (Fig. 1 /3)
CAUTION!
Make sure that the surface can withstand the
rotating brush without becoming damaged.
• Parquet brush (gentle on oors) (Fig. 2/D )
• 3-in-1 combo nozzle (brush for joints, furniture &
upholstery) (Fig. 1/4 )
• Long exible crevice nozzle (Fig. 2/A )
• Extended exible furniture brush (Fig. 2/B )
ᆻSwitch on the appliance. ᆼVacuum-clean the oor
or the piece of furniture. ᆽActivate or deactivate the
rotating brush roller on the combo oor nozzle as re-
quired using the button on the top of the appliance
(Fig. 7 /1). ᆾSwitch o the appliance.
!
17 EN