Displays2go QCRND17PBK User manual

QCRND17PBK
Item Name Qty Image
M4x10mm Screw 4
M5 Nylon Lock Nut 4
M5x16mm Screw 4
Double Hole T-Slot Nut 2
Single Hole T-Slot Nut 2
M4 Washer 4
M4x12mm Screw 2
M6x30mm Screw 2
M6 Serrated Lock Washer 2
1

2
QCRND17PBK
Hole for top of snap frame
Holes for T-slot mounng
Hole for boom of snap frame
Holes for mounng Purell Dispenser
Top Acrylic
Bent Acrylic
2

3
Aach bent acrylic panel using 1x
M4x10mm screw, M4 washer, and
double hole T-slot nut as shown.
Snap open the top and boom rails
of the snap frame to expose the
mounng holes. Using the hole
nearest the tab at the top of the
Bent Acrylic piece, mount the snap
frame using 1x M4x12mm screw
and single hole T-slot nut. (Frame
not shown)
QCRND17PBK
3

4
Aach the Base Plate to the
Extrusion using 2x M6x30mm
Screws and M6 Serrated Lock
Washers.
Pivot the frame out of the way and install
second double hole T-slot nut in the lower
hole. Slide the assembly further down the T-
slot and ghten all the screws as needed.
Aach the top of the snap frame using the
top slot on the top acrylic piece and the re-
maining single hole T-slot nut.
QCRND17PBK
Aach the Purell Dispenser to the
Bent Acrylic, using the adhesive back-
ing aached to the Purell Dispenser.
Align the 4 holes in the Bent Acrylic
with the corresponding 4 holes visible
on the inside of the Purell Dispenser.
Use the M5x16mm Screws and M5
Nylon Lock nuts with the 4 aligned
holes to futher secure the Purell Dis-
penser.
4