Displays2go SMSDWDK User manual

1
To attach lid, peel red film off tape on hinge. Center the lid on the body
and stick the hinge to the body.
SMSDWDK, SMSDWLT
Hand Sanitizer Dispenser with Wood Grain Cover V20.12
Take the two small bolts and hex-nuts and thread them through the two
bottom holes in the center of the body. Fold up all 4 sides of unit.
Hinge
Front Cover
To lock in place, flex the sides in far enough to get the tabs through the
slots in the top and bottom. Once through, flex the sides back outwards to
lock the box in place.
3
Body
Sanitizer Dispenser
Hardware

2
Scan QR code to visit
the product page:
To attach hand sanitizer dispenser, use the key holes in the back of the unit.
Place the dispenser into the box and drop down locking the key holes onto
the previously installed bolts. To attach the unit to the wall, take the two
pointed screws and thread them through the two top holes in the body.
To refill dispenser, lift-up front cover and slide dispenser up to release it
from the key holes. Once the dispenser is removed, pull down on the front
of the dispenser to expose the fill jug inside. Refill with sanitizer and then
place back into box and slide down securing back onto the keyholes.
5
Assembly Instructions
SMSDWDK, SMSDWLT
Hand Sanitizer Dispenser with Wood Grain Cover V20.12
If you have any questions regarding our products, please visit us at
www.displays2go.com or contact D2G customer service 844-221-3388.