DIVERSIFIED WOODCRAFTS 250508 User manual

1
1
2
2
AA
ASSEMBLY INSTRUCTIONS
EQUIPMENT STANDS
250508 30"W x 25"D x 24"H
250509 30"W x 37"D x 24"H
250510 24"W x 24"D x 20"H
HARDWARE INCLUDED
Item Item # Qty Description
D Set Screw **16 M8 x 8mm Allen Set Screws
EAllen Wrench 14mm Allen Wrench
PARTS INCLUDED
Item Item # Qty
ATop 1
B Shelf 1
CLeg 4
A
B
C
DE
Turn over page for step by step instructions
*
Equipment Stands

1
1
2
2
AA
BB
J
1. Confirm all parts/hardware are included
2. Determine the height that you wish the shelf to be placed at and measure that distance up on each leg.
If you wish to change the height, the shelf may be adjusted after installation. Once the shelf isin its proper location, tighten in
place with set screws and allen wrench that are provided. Note: Install one leg at a time
3. Turn table top upside down on a clean surface to avoid scratching. Assistance will be needed. Place legs into leg sockets
and tighten the set screws, as was done on the shelf. Once all the screws are properly tightened, the table is ready to be
flipped right side up. Once right side up, if needed, adjust feet to level the table.
DD