DIVERSIFIED WOODCRAFTS Shain CDTC-1VT User manual

[1]
CDTC-1VT
ASSEMBLY INSTRUCTIONS
*Model views may not represent exact model purchased

[2]
TABLE OF CONTENTS
ASSEMBLY COMPONENTS_______________________________________ 3
LEG LEVELER ATTACHMENT_____________________________________ 4

[3]
ASSEMBLY COMPONENTS
ITEMS INCLUDED
PART #
PART#
2-SUPPORT,RATCHET
100956
3-TRUSS,MPL,1.00X1.50X34.88
229190-
3488
4- LEG LEVELER,BLK BASE 1
100079
3- SCREW,#6X3/4 TRUSS
HEAD,QUAD,BLACK
236263
1- CAB,BASE,DBL SIDED,10.5X22.38X23.75
237959
1-TOP,FIBERESIN,.75X30X42
18-0008
1-LEG,PANEL,PED,ASSY,30H,LEFT
229204_CDTC_1VT
1-TOP,FIBERESIN,.75X9.88X42
229107
1-LEG,PANEL,PED,ASSY,30H,RIGHT
229205
1-PENCIL LEDGE
14-0027
1-STRETCHER,LEG,MPL,.81X2.50X24.38
229011
2-SOFT CLOSE
100957
REV DESCRIPTION DATE
---
Original Created
8/19/10
DK

[4]
Assembly Instructions
Items not included but needed for assembly:
1. Philips Head Screwdriver
Instructions:
1. Lay the table on the floor with the top of the unit using facing downward. (Be
sure to lay the table on a clean surface so you don’t damage the tabletop.
2. Screw the leg levelers (part #100079 into each t-nut located in the bottom each leg
assembly.
3. Turn the table over so the top is up. Set your table in place and adjust the leg
levelers to level the table.
Attach 4 leg levelers
to the bottom of the
PT foot

[5]
4. Next, you will be attaching the pencil ledge using a Philips head screw driver.
The top should have already been pre-drilled, for locating the pencil ledge,
however if the top wasn’t already pre-drilled please do so now, with a 1/8” drill
bit (this will help prevent the top from splitting). The hardware used to attach the
pencil ledge should be provided, and should be a #6 screw X3/4 TRUSS HEAD,
QUAD, BLACK, part number of 236263.
Attach pencil ledge to the
front of the adjustable top.

[6]