Dometic ZAMP SOLAR User manual

PORTABLE QUICK START
GUIDE
1. Remove Portable from the rigid nylon travel
case.
2. Unlatch the butterfly clasps (45watt does not
have clasps) and open panels flat.
3. Unfold tilt legs and place panels in direct
sunlight.
4. Clip the red alligator clip to the negative
battery terminal.
5. You are now charging your batteries.
1. Remove Portable from the rigid nylon travel
case
2. Unlatch the butterfly clasps (45watt does not
have clasps) and open panels flat.
3. Unfold tilt legs and place panels in direct
sunlight.
4. Remove/unclip the alligator clips at the SAE
connection.
5. Plug the SAE lead from the panel into the
sidewall port on your RV.
6. You are now charging your batteries.
* First time you use the unit you may need to configure the charge controller for the
appropriate battery type.
[phone]
ZampSolar.com
ALLIGATOR CLIPS
SIDE WALL
SOLAR PORT

WIRING FOR MULTIPLE 12V BATTERIES
When wiring a solar port to multiple batteries, it is important to
remember that your batteries are wired together. To gain the most
from your solar, be sure to place the positive wire on the first battery
in the sequence and the negative wire on the last battery in the
sequence. This is true regardless of the number of batteries in the
bank.
[phone]
ZampSolar.com
PORTABLE QUICK START
GUIDE
Overcurrent
Protection
Overcurrent
Protection
How TO wire a solar port
for 2 batteries
How TO wire alligator cips
for 2 batteries
How NOT to wire
a solar port for 2 batteries
How NOT to wire
alligator clips for 2 batteries
How TO wire alligator clips
for 3 batteries
How TO wire a solar port
for 3 batteries