www.doro.com 3
English
Turning on/off
Use the switch 0/1 on the side of the monitor to turn the unit on or off.
Connection/Monitoring
1. Connect the mains adapter to an electrical wall socket.
2. Make sure that the monitor and handset are set to the same channel and transfer
code. See below.
3. Position the monitor close to the baby (but out of reach).
4. Adjust the microphone sensitivity using the VOX control on the rear of the monitor
(A=least sensitive....H=most sensitive). Please refer to page 4.
5. When the sound level in the room exceeds the selected VOX setting, the handset
will be triggered allowing you to monitor the room.
6. Try the installation before every use by talking quite low into the unit that is placed
close to the baby, at the same time as someone is listening to the other unit.
Please note!
If the monitor and handset/s are unable to communicate it may be because you are using different
channels or transfer codes, the battery is running low or the units are too far apart.
There is NO loudspeaker in the monitor, this ensures your child will not be disturbed by ‘radio chatter’
that is often heard on the handset/s.
Important!
Please note when programming all references to press = to press and then immediately release the button.
Channel selection
All UHF/CB radio equipment share the available designated channels. If the chosen
channel is in use select an alternate channel, the selected channel number will be
displayed in standby mode. Please refer to the frequency/channel allocation table on
page 6.
1. Press MENU. CH will be displayed.
2. Scroll to the desired channel using v/V
.
3. Within a few seconds the display will return to standby mode.
Transfer code selection
There are 38 transfer codes available which can be used to lter out unwanted signals.
To enable monitoring, the same transfer code must be used on the monitor and all
handsets. However, the communication between monitor and handset/s may still be
overheard irrespective of which code is used.
1. Press MENU repeatedly until Ct is displayed.
2. Scroll to the desired transfer code using v/V
.
3. Within a few seconds the display will return to standby mode.
