Dräger BG ProAir User manual

Dräger BG ProAir
Donning
D-36054-2021
Tighten the straps from bottom to
top.
Fully open the cylinder valve.
Remove the sealing cap from the
mouth piece, breathe in and hold
your breath. Push the mouth piece
into the connection piece of the
mask until it engages audibly.
Breath normally.
Leak test:
Tightly squeeze the inhalation hose
and breathe in until a vacuum is
produced. Hold your breath for
about ten seconds. The vacuum
should be maintained. If not, tighten
the straps of the mask.
Perform the pre-operation check –
see also backpage.
Ready for use.
Lift up the device over your head
and place it on your back. Tighten
the shoulder straps until the
waistbelt pad is aligned with your
hips.
D-5708-2021D-5735-2021D-5755-2021
Spread the harness of the
facemask and place it over your
head.
Optional: Close the buckle of the
chest straps. Tighten the straps.
Adjust the shoulder straps again,
loosen them a little if necessary.
Most of the weight should rest on
your hips.
Make sure the shoulder and waist
belt straps are fully opened. Place
the breathing hoses on the back
of the device. Reach through the
shoulder straps with both arms.
D-5700-2021D-5730-2021D-5772-2021
Close the waistbelt buckle. Pull the
straps forward until the apparatus is
secured on your hips.
D-5719-2021D-5745-2021D-5762-2021
Pull the adjusting straps forward
until the apparatus is secure with
the buckle in center of the body.
D-5726-2021D-5750-2021D-5775-2021
www.draeger.com
DMC-102039 | 22.02-1 | HQ | PP |Subject to modications | © 2022 Drägerwerk AG & Co. KGaA

Dräger BG ProAir
Pre-operation check
D-36054-2021
www.draeger.com
DMC-102039 | 22.02-1 | HQ | PP |Subject to modications | © 2022 Drägerwerk AG & Co. KGaA
Open the cylinder valve completely.After 15 seconds the test is
completed.
The Electronic Control Unit (ECU)
starts automatically and performs
a self-check.
D-5708-2021
Leave the sealing cap on the
mouthpiece. Open the cylinder
valve fully or at least two turns.
D-5772-2021D-5810-2021 / D-5814-2021
Battery test:
The battery level is shown.
Green: Battery fully charged.
Yellow: Replace the battery but it is
acceptable to safely use the Dräger
BG ProAir for up to four hours.
Red: Battery must be replaced
before any operation.
D-5719-2021
D-5772-2021
High-pressure leak test:
Conrm the high-pressure leak test
on the display. The cylinder must be
charged to at least 150 bar. Close
the cylinder valve when indicated on
the display and conrm to start the
test.
D-5808-2021