Dräger Fabius Series Quick start guide

D-58067-2012
Disassembly
Remove all hoses, cables
and the absorber, lift off the
breathing system.
Mount the breathing system,
connect all hoses, cables
and the absorber.
Unscrew CLIC adapter (optional)
or absorber canister. Inspect the
CLIC adapter seal.
Make sure all seals are in place.
Screw on CLIC adapter (optional)
or absorber canister.
Remove inspiratory and
expiratory valve.
Loosen and pull out expiratory
port; pull out flow sensor.
Remove flow-sensor guard.
Remove waste-gas port.
Mount waste-gas port.
Remove hook for gas sample
line (optional).
Remove cover of ventilator
chamber, remove ventilator
diaphragm.
Assembly
Remove cleaning disc from
the adapter. Close adapter
until it snaps.
Insert cleaning disc into
the adapter. Close adapter
until it snaps.
Remove APL-valve.
91 02 535 | 16.08-1 | HQ | PP | Subject to modifications | © 2016 Drägerwerk AG & Co. KGaA
Mount hook for gas sample line
(optional).
Mount APL-valve.
Attach flow-sensor guard. Insert
flow sensor, insert and tighten
expiratory port.
Mount inspiratory and expiratory
valve.
Insert ventilator diaphragm
and mount cover of
ventilator chamber.
Dräger Fabius Family
Compact Breathing System
Disassembly/Assembly

Manual cleaning
and disinfection
Machine cleaning
and disinfection
Sterilization
After the machine cleaning and disinfection,
a hot steam sterilization is required to dry the
breathing system. Valves, ventilator cover,
and AGS sleeve: Make sure that the cleaning
and rinsing liquids can flow in the opening
direction of the valve. Remove any water
which may have accumulated in the ventilator
diaphragm. For further instructions and
explanations please see the respective
instructions for use.
Visual check
Position components so that all interior spaces and surfaces are completely flushed and water can drain off freely.
This guideline does not replace the instruction for use.
D-58067-2012
Dräger Fabius Family
Compact Breathing System
Reprocessing Instructions