Draco K7-1 User manual

Manual
Max Draenert Apparatebau GmbH & Co. KG
Gutenbergstrasse 15-17
D-73779 Deizisau
:[phone]
:www.dracotools.com
@: [email protected]
Item no.: Closing length Length WeightWidthSeam height
91515-1210 mm 310 mm 3,3 kg320-610 mmfrom 25 mm/1“
Double lock hand seamer
K7-1
Read, observe and follow this manual
and the other applicable documents,
especially all safety instructions and
warnings. Keep the manual for future
consultation.
Always wear protective gloves!

1. Tool elements
2. Intended use
The K7-1 double lock hand seamer can only be used to manually close of the
pre-closed standing seam to a double standing seam in the material thicknesses
mentioned under point 3.
3. Max. thickness of materials
Copper / Zinc / Aluminium until 0,80 mm
Steel until 0,80 mm
Stainless steel until 0,50 mm
4. Maintenance
All parts of the hand seamer are standardized, exchangeable, made of rustproof
materials and thus largely maintenance-free. The two side guides (E) should be
lubricated with grease periodically.
5. Accessories and additional tools
If it is difficult to use the hand seamer K8 in hard to get at places
(e.g. chimney-windows etc.) the closing handle can be exchanged by
a 90° closing handle, item no. (Item No.: BGKH70008)
The hand seamer K8-1 closes pre-profiled panels in one
operation to a standing seam and a tight joint.
(Item No.: 91520)
A
D
C
AClosing handle
BEccentric lever
CApply handle
DClamping hooks
ESide guides (L+R)
B
Manual
E

6. Operation method
Fig. 1:
Starting position:
Eccentric lever in "OPEN" position (parallel to
seam) and closing handle in open position.
Place the K7-1 like here
shown on the seam.
Fig. 2:
2.1 Eccentric lever in "CLOSED" position (parallel to
Apply handle) so that both clamping hooks are locked
under the standing seam.
2.2 Counter-press the apply handle
and press down the closing handle.
The double lock seam is closed.
Fig. 3:
3.1 Closing handle back in starting position.
3.2 Tap and hold the eccentric lever with your thumb.
This releases the clamping hooks.
Important: It is irrelevant whether the eccentric lever
is pressed to the left or to the right and a little pres-
sure
sideways is enough to be able to move the tool.
Fig. 4:
slightly lift and move the tool by
approx. 1/2 to 3/4 of the tool width.
Repeat locking process, start
over at Fig. 2.
Video: K7-1 + K8

Manual
Max Draenert Apparatebau GmbH & Co. KG
Gutenbergstrasse 15-17
D-73779 Deizisau
:[phone]
:www.dracotools.com
@: [email protected]
7. Spare parts