Draytek VigorSwitch G1241 User manual

V
Vi ig go or rS Sw wi it tc ch h G G1 12 24 41 1
2
24 4 G Gi ig ga ab bi it t P Po or rt t
W
We eb b S Sm ma ar rt t S Sw wi it tc ch h
Quick Start Guide
European Community Declarations
Manufacturer: DrayTek Corp.
Address: No. 26, Fu Shing Road, HuKou Township, HsinChu Industrial
Park, Hsin-Chu, Taiwan 303
Product: VigorSwitch G1241
DrayTek Corp. declares that VigorSwitch G1241 is in compliance with the
following essential requirements and other relevant provisions of 2004/108/EC.
The product conforms to the requirements of Electro-Magnetic Compatibility
(EMC) Directive 2004/108/EC by complying with the requirements set forth in
EN55022/Class A and EN55024/Class A.
The product conforms to the requirements of Low Voltage (LVD) Directive
2006/95/EC by complying with the requirements set forth in EN60950-1.
Federal Communications Commission (FCC) Statement
This equipment has been tested and found to comply with the limits for a class
A computing device pursuant to Subpart J of part 15 of FCC Rules, which are
designed to provide reasonable protection against such interference when
operated in a commercial environment.
All trade names and trademarks are the properties of their respective companies.
© 2014. All Rights Reserved.
Version: 1.0
Date: September 16, 2014

Package Content
The 24-port Gigabit Web Smart Switch is a standard switch that meets all
IEEE 802.3/u/x/z Gigabit, Fast Ethernet specifications. The switch has 24
10/100/1000Mbps TP ports.
The network administrator can logon the switch to monitor, configure and
control each port’s activity. In addition, the switch implements the QoS
(Quality of Service) and VLAN. It is suitable for office application.
VigorSwitch Rack Mount Kit Quick Start Guide
and CD
The type of the power cord depends on the country that the switch will be
installed:
UK-type power cord EU-type power cord USA-type power cord
Note: If any of these items is found missing or damaged, please contact
your local supplier for replacement.

Descriptions of Panel
LED Explanation
LED Color Explanation
Steady Green The switch is powered on.
PWR Off The switch is powered off.
Steady Green The switch is on and functioning properly.
Blinking Green The switch is rebooting and performing self-diagnostic tests.
SYS Off The power is off or the system is not ready / malfunctioning.
Steady Green The link to a 10/100/1000 Mbps Ethernet network is up.
Blinking Green The system is transmitting / receiving to/from a 10/100/1000
Mbps Ethernet network.
Link/ACT
Off Port disconnected.
Connector Explanation
Interface Description
Reset Button Reset the switch to its factory default configuration via the
RESET button. Press the RESET button for three seconds
and release. The switch automatically reboots and reloads its
factory configuration file. The RESET button is on the front
panel of the switch.


Installing Your Switch
A hierarchical network with minimum levels of switch may reduce the timing
delay between server and client station. Basically, with this approach, it will
minimize the number of switches in any one path; will lower the possibility of
network loop and will improve network efficiency.
If more than two switches are connected in the same network, select one switch
as root switch and connect all other switches to it. This is general if no VLAN or
other special requirements are applied.
All switch ports are in the same local area network.
(*The switch image is sample only)
For other examples of hardware installation, please refer to User’s Guide for
detailed information.