Drive 17100 User manual

hip-high chair
www.drivemedical.com
WARNING:
This Product has a maximum user weight limitation of
300 lbs.
Drive Medical assumes no responsibility for any damage
or injury caused by improper installations, assembly, or
use of this product.
If components are missing or damaged, please contact
your dealer immediately. DO NOT use substitute parts!
NOTE:
Do not use the chair until all the assembly steps have
been completed
Warranty:
- 2 year on the frame and 1 year on upholstery
MAINTENANCE
Check all hardware periodically for tightness
item 17100 shown
two year limited
warranty
Your Drive brand product is warranted to be free of
defects in materials and workmanship for two years
from the date of the original consumer purchase.
This device was built to exacting standards and
carefully inspected prior to shipment. This Two
Year Limited Warranty is an expression of our
confidence in the materials and workmanship of
our products and our assurance to the consumer of
dependable service.
In the event of a defect covered by this warranty, we
will, at our option, repair or replace the device.
This warranty does not cover device failure due to
owner misuse or negligence, or normal wear and
tear. The warranty does not extend to non-durable
components such as rubber accessories, casters, and
grips, which are subject to normal wear and need
periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized
Drive dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China

assembly / operating
instructions
Screws
Frame
Armrest
Footrest
Screws
Frame
Armrest
Footrest
1. Remove the frame and seat assembly from the
carton. Stand chair upright on all four legs.
2. Remove the (4) Phillips screws holding the seat to
the bottom side of the frame, taking care to
support the seat so it does not fall when the screws
are removed.
3. Position the seat on the topside of the frame
making sure the seat faces forward to the footrest
support on the bottom front of the frame.
4. Reinsert the (4) Phillips screws through the bottom
of the frame into the bottom of the seat. Be sure
to use the long screws in the front of the seat and
the short screws in the rear of the seat. Take care to
start all (4) screws by hand before tightening them
with the screwdriver.
(Failure to start the screws by hand can cause
permanent damage to the seat assembly)
5. Remove the (2) Phillips screws holding the armrest
to the bottom side of the chair arm. Reposition
the armrest to the topside of the chair arm and
install the (2) screws by hand before tightening them
with the screwdriver. Repeat the armrest installation
on the other arm.
6. The Drive Hip-High Chair features an adjustable
height footrest. To install, position the footrest with
the rounded corners facing outward and the square
corners facing under the chair. Position the wooden
dowels on the footrest into the desired height
setting until the footrest is flush with the chair.
Install the (4) screws provided (2 per side) into the
holes provided in the back of the chair rail. Tighten
all 4 screws into the footrest.
chair as shipped
armrest assembled
seat & footrest assembled
Seat Frame
Armrest
Footrest
(Select Position)
Screws
footrest installation
Screws
Securing
Footrest
To Leg
Footrest
Predrilled Holes
For Adjustable
Footrest
Lower
Side Rail
Front Leg