Drive 15065 User manual

bed side helper
item # 15065
www.drivemedical.com
lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards
and carefully inspected prior to shipment. This
Lifetime Limited Warranty is an expression of our
confidence in the materials and workmanship of
our products and our assurance to the consumer
of years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
www.drivemedical.com

When properly aached to a metal bed frame, per
the instructions below, this product is intended to
assist a person in siing up from a prone position
in bed. It is also intended to help a person stand
up or sit down while geing into and out of bed.
assembly instructions
CAUTION:
This product is not intended to support full
body weight.
Do not use as a ladder or stand on crossbars.
Do not use as a walker.
1. Remove Bed Side Helper (1) from the shipping
container and cut the plastic strap retaining
the hardware bag. Thread the leveling glides
(3) into the boom holes. If the unit will be
used in a room with carpeting, snap the carpet
grippers (4) onto the leveling glides.
2. Make sure the boom clamp (2) is assembled
with the tabs inserted into the slots of the
Bed Side Helper, with the tabs facing up Fig. 1
3. Unthread the two clamping knobs (5) from the
boom, just far enough to keep them from
falling out. Fig 2
4. Aach the assembled Bed Side Helper to the
side of the metal bed frame, approximately
24 inches from the headboard. Select a
location within a comfortable reach for the
person who will be using Bed Side Helper. Slip
the rolled-over lip on the vertical plate over
the bed frame channel and tighten the
clamping knobs (5) to press the boom clamp
(2) against the boom of the frame. Make
certain that the boom clamp fits over the
inner edge of the bed frame and the frame is
securely locked in position. Fig. 3
5. Adjust the leveling glides down to contact the
floor. Adjust all four glides evenly, using
the 1/2” open-end wrench (provided) to turn
the adjusting nut.
FIGURE 2
FIGURE 1
FIGURE 3