JetForce Pro 3
Do not open the front panel.
This may cause an electric shock.
Supervise children at all times.
Do not let them play with the unit.
Do not use in a wet environment, for example, near a bath
or a shower where it may get direct water and places where
condensation may form, otherwise this may cause electric
shock and unit malfunction.
Do not allow the unit to get wet,
otherwise it will cause electric shock.
Do not modify and disassemble the unit unnecessarily.
Otherwise this may cause a fire, electric shock or personal injury.
Rated power is required.
If power tolerance is over +/- 10%, there will be breakdown.
If using incorrect power supply, fire, electric shock and
machine malfunction will happen.
Please, use dedicated socket.
If using together with other appliances, the socket
may cause abnormal heat leading to fire.
Power must be cut off during maintenance to prevent
the risk of electric shock.
Drain tank and air filter must be installed.
Do not switch on after power connected for 10 seconds.
If machine doesn't work or have abnormal conditions,
please, cut off power to prevent accidents; and close leakage
circuit breaker and ask supplier to check and repair, or it may
lead to fire because of electricity leakage and short circuit.
It must have a reliable grounding wire otherwise it may cause
electric shock risk when unit failure or leakage.
Attention when installing:
Do not install when the machine is connected to the power.
It must be installed by a professional person.
If the installation is incorrect, it may cause electric shock and fire accident.
This appliance is not intended for use by people (including
children) with reduced physical, sensory or mental capabilities,
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
If the cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified people in
order to avoid a hazard.
For additional protection, the installation of a residual current
device (RCD) having a rated residual operating current not
exceeding 30mA is advisable in the electrical circuit supplying
the bathroom. Ask your installer for advice.
