Start Up
If the power up (from Standby mode or otherwise) is successful, the appropriate
interface will be displayed aer a launch sequence of several seconds. The wireless
LAN connecon may take 10-15 seconds to be established.
Configuring the Mobile Tablet
The DT313SC/ DT313T may be congured using the ulies and methods dictated
by the soware operang system. The DT313SC/ DT313T should be congurable
for various properes such as user proles, network features, and several system
elements.
Wireless Networking
Wireless LAN
The DT313SC/ DT313T is oen delivered with an embedded (user-inaccessible)
802.11ac WLAN adapter equipped with a hidden custom antenna.
•Through the support of typical WLAN adapters, the DT313SC/ DT313T should be
able to detect all 802.11 access points in the vicinity for you to select the access
point of your choice for connecon.
•The SSID and WEP/WPA/WPA2 (if enabled) parameters on the DT313SC/ DT313T
and the access points have to match. The SSID is case-sensive and it is recom-
mended that you enable WEP/WPA/WPA2 encrypon (or advanced alternaves)
for secure access.
•When WEP/WPA/WPA2 is enabled, you may need to consult your network
administrator or your networking equipment literature to properly congure
associated sengs such as Authencaon mode, etc.
•Refer to the access point operang manuals for seng up the 802.11 access
points.
OPERATION
Internal Battery
Warning! !
The internal baery pack should only be replaced by an authorized DT Research service
representatve. Please contact your product and/or service provider for internal baery
replacement service.
Powering ON and OFF
To acvate the DT313SC/ DT313T, push and quickly release the Power Buon. The
display will come on in a few seconds. To put the DT313SC/ DT313T in Standby mode,
push and quickly release the Power Buon. To turn the DT313SC/ DT313T off for
extended storage, power off safely using any soware funcon that “shuts down
computer” provided in the soware operang system.
NOTE:
The baery packs shipped with your tablet may be low in power—please use
the AC-DC adapter with the DT313SC/ DT313T when seng up for the rst me
to fully charge the internal baery pack.
NOTE:
When the baerypack(s) is (are) charging, the blue-colored Baery LED should
blink slowly. If plugging in the AC-DC adapter does not trigger this blinking
acvity and the LED stays dark, the baery pack(s) may have been drained
substanally. Try unplugging/ replugging the AC-DC adapter to the DT313SC/
DT313T a few mes to acvate the charging process.
NOTE:
To conserve power, use (push and quick release) the Power Buon to put the
tablet in “Standby” mode while not in use. Pushing briey on the same buon
will wake up the system within seconds.
NOTE:
Avoid using the Power Buon (“hold 4+ seconds” feature) to turn off the
tablet—this form of hardware shutdown is intended to be a means of recovery
from lockups, and not as normal operaon.
45
