CONTROLS
MOD switch toggles modulation
on/o (blue LED indicates on)
MIX knob controls blend of
wet and dry signals
REGEN knob sets number
of repeats
DELAY knob sets delay time
FOOTSWITCH toggles
eect on/bypass (blue LED
indicates on)
SAMPLE SETTINGS
M169 CARBON COPY®ANALOG DELAY
DESCRIPTION
• 100% analog bucket-
brigade technology
• Up to 600ms of delay with
switchable modulation
• Internally adjustable
modulation circuit
• True bypass
DIRECTIONS
• Run a cable from your guitar
to the M169’s INPUT jack and
another cable from the M169’s
OUTPUT jack to your amplier.
• Start with all controls at
12 o’clock.
• Turn the eect on by depressing
the footswitch.
• Rotate the REGEN knob clock-
wise to increase the number of
repeats or counterclockwise to
decrease it.
• Rotate the MIX knob clockwise
to increase the ratio of wet to dry
signal or counterclockwise to de-
crease it. Fully clockwise results
in half wet/half dry mix while fully
counterclockwise results in
100% dry signal.
• Rotate the DELAY knob clockwise
to increase delay time or counter-
clockwise to decrease it.
• Push in the MOD switch to add
modulation to your delay signal.
Modulation width and speed
can be adjusted internally
(remove bottom plate) with
a 3mm slotted screwdriver
(see Diagram A).
MEMPHIS SLAP SKANK’N DUBGOLDEN AGE
GUITAR GOD
DUNLOP MANUFACTURING, INC.
P.O. BOX 846, BENICIA, CA 94510 U.S.A.
TEL: 1-707-745-2722 FAX: 1-707-745-2658
POWER
The Carbon Copy Analog Delay
is powered by one 9-volt battery
(remove bottom plate to install),
a 9-volt AC Adapter such as the
Dunlop ECB003/ECB003EU, or
the DC Brick™ and Iso-Brick™
power supplies.
SPECIFICATIONS
Input Impedance 1 MΩ
Output Impedance 1 kΩ
Max Input Level +5 dBV,
500 Hz
Max Output Level +8 dBV
Noise Floor*
Mix at Max CW -96 dBV
Mix at Max CCW -104 dBV
Delay Distortion <1%, 1 kHz,
-5 dBV Input
Delay Time 20 ms to
600 ms
Noise Reduction 2:1 ratio
Modulation Speed 0.2 Hz to
2.2 Hz
Bypass True Hardwire
Current Draw 26 mA
Power Supply 9 volts DC
*Regen at max CCW, A-weighted
DIAGRAM A
