Dunlop MXR PHASE 95 User manual

92503020559REVB
M290 PHASE 95

1
M290 PHASE 95
DIRECTIONS
• Run a cable from your guitar to
the M290’s INPUT jack and run
another cable from the M290’s
OUTPUT jack to your amplifier.
• Set SPEED knob to its
12 o’clock position.
• Turn the effect on by
depressing the footswitch.
• Push the 45/95 switch to
select desired phaser mode:
Phase 45 (red LED) or
Phase 90 (blue LED).
• Rotate the SPEED knob
clockwise to increase rate of
effect or counterclockwise
to decrease it.
• Engage the SCRIPT switch for a
subtler vintage sound, indicated
by amber LED.
POWER
The Phase 95 is powered by the
Dunlop ECB003 9-volt adapter,
or the DC Brick™ , Iso-Brick™ , and
Mini Iso-Brick™power supplies.
This pedal cannot be powered
by a battery.
CONTROLS
1 SCRIPT switch removes
feedback from circuit
(indicated by amber LED)
2 45/90 switch toggles between
Phase 45 (red LED) and Phase
90 (blue LED) modes
3 SPEED knob controls rate
of effect
4 FOOTSWITCH toggles
effect on/bypass (blue LED
indicates on)
DUNLOP MANUFACTURING, INC.
P.O. BOX 846 BENICIA, CA 94510 U.S.A.
TEL : [phone] FA X: 1-707-745-26 58
3
2
4
The MXR Phase 95 combines two iconic
phase circuits into a single mini housing:
the two-stage Phase 45 and the four-stage
Phase 90. The 45/90 switch toggles between
the two, while the Script switch removes
feedback for a subtler vintage sound.
SPECIFICATIONS
Input Impedance 800 kΩ
Output Impedance < 6 kΩ
Max Input Level -8 dBV
Max Output Level 8 dBV
Noise Floor* -95 dBV
Speed Range 0.125 Hz to 10 Hz
Power Requirements 8 mA @ 9VDC
All measurements made at 1 kHz, speed at mid position.
*A-weighted.