Dunlop SC 95 Slash Cry Baby User manual

DUNLOP MANUFACTURING, INC. P.O. BOX 846 BENICIA, CA 94510 U.S.A. TEL: [phone] FAX: [phone]
Jimdunlop.com
SC95 SLASH CRY BABY CLASSIC WAH OWNER’S MANUAL
92503012781revB
CRY BABY CLASSIC WAH

SC95 SLASH CRY BABY®CLASSIC WAH
POWER
The Slash Cry Baby Classic Wah is powered by one 9-volt battery (accessed via bottom
of pedal), a 9-volt AC adapter such as the Dunlop ECB003/ECB003EU, or a DC Brick™
power supply.
SETUP INSTRUCTIONS
• Run a shielded instrument cable from your guitar to the SC95’s Instrument jack.
• Run another shielded instrument cable from the SC95’s Amplifier jack into your
amplifier input.
• Turn on the amplifier and begin playing.
• To turn the pedal on/off, push the toe of the pedal down until you feel a “click”.
• By rocking your foot back and forth on the pedal, you can change the effect that
the SC95 has on the tone of your instrument instantaneously.
• Blue LEDs on both side’s of the pedal indicate ON/OFF status.
SPECIFICATIONS
Inductor Custom wound low noise 560 millihenry high "Q" torroid
Input Impedance .7 MEG
Output Impedance <1 K
Sweep range 340 Hz - 1.7 KHz
Signal To Noise >102 dB A weighted
Bypass Hardwire DPDT bypass
Effect on LED's Located on both sides of pedal
Power Requirements +9 VDC @ <3 ma., 5.5mm x 2.1mm positive barrel & negative
center or standard 9-volt battery.
SLASH-APPROVED TREAD
HEAVY DUTY
BYPASS SWITCH
ON/OFF STATUS LEDS
TOP-QUALITY INPUT
AND OUTPUT JACKS